ASE certification/ASE MLR Certification/ASE Brake Certification/ASE A4 /Electrical/Electronic Systems /ASE A5/Engine Performance/ASE A6/ASE A1/ASE B6 /Heavy truck brakes/ASE G1/ Exams Package Deal Full Solutions Pack

Air in Hydraulic System - ANSWER-A spongy brake pedal may be caused by Excessive tire pressure - ANSWER-Can not cause very erratic brake pulling while applying brakes Excessive brake pedal travel - ANSWER-A power assist brake booster push rod that is too short will cause Brake drum machined...

ASE Certification Chapter 35 Exam-Solved

ASE MLR Certification Test Answered 100% Correct

DoubleFlare - ANSWER-Two step process that creates a double thickness of line at seal. ISO Flare - ANSWER-One step process that creares a "bubble" on the end of the line less likely to leak and less likely to be over tightened. Banjo - ANSWER-Bsing a fitting that resembles a 'banjo" and a ...

How do gear sets create mechanical advantage? - ANSWER-They do so by having different ratios. Gears with the same number of teeth have a ratio of 1:1, meaning that this set of gears have no mechanical advantage. They turn at the same speed because of the same number of teeth. Drive gear - ANSWER-...

2. A driver says that the front end of his car vibrates up and down while traveling at most road speeds. Tech A says that too much runout of the front wheels could be the cause. Tech B says that a static out of balance of the front wheels could be the cause. Who is right? A. Tech A only B. Tech B ...

a 1. Check electrical circuits with a test light; determine needed repairs. - ANSWER-Test circuits with a volt meter or test light. If the component is getting the required voltage, but non-operative, there is a good chance that component is bad and should be replaced. a2. Check voltages and volt...

The front end of a vehicle vibrates up and down while traveling at most road speeds. Technician A says that too much radial runout of the front tires could be the cause. Technician B says that static out-of-balance of the front tires could be the cause. Who is right? (A) A only (B) B only...

A spongy brake pedal may be caused by: a. ABS Diagnostic Trouble Code set b. Frozen caliper piston c. Defective metering valve. d. Air in hydraulic system - ANSWER-D This question is not like the others. It has the word EXCEPT. For this question, look for the choice that could NOT cause the d...

The acceptable amount of alcohol mixed with gasoline (non E-85) is: - ANSWER-Up to 10 percent. When the pressure in the intake manifold increases, the fuel pressure regulator on a port fuel injection system: - ANSWER-Increases fuel pressure. Technician A says to relieve pressure on an PFI (por...

which battery rating is tested at 0 deg F (-18 C)? - ANSWER-cold-cranking amperes (CCA) battery electrolyte is a mixture of water and ________. - ANSWER-sulfuric acid each automotive battery cell has an electrical potential of how many volts? - ANSWER-2.1 V the largest percentage of automot...

mega or "M" stands for how many - ANSWER-100000 or move decimal 6 places to right kilo or (k) stands for how many - ANSWER-1000 or move decimal 3 places to the right milli (m) stands for how many - ANSWER-.001 or move decimal three spaces to the left micro (u) stands for how many - ANSWER...

A compression test shows that one cylinder is too low. A leakage test on that cylinder shows that there is excessive leakage. During the test, air could be heard coming from the tailpipe. Which of the following could be the cause? A. Broken piston rings B. Bad head gasket C. Bad exhaust gasket D...

What is the difference between a unitized frame and a uni-body? - ANSWER-There is no difference. In a uni-body or unitized vehicle, the frame and body are incorporated into a single welded structure. Should exhaust damaged systems be welded and repaired, or replaced all together? - ANSWER-Replace...