MSSC QUALITY CERTIFICATION EXAM Q&A

Production personnel use standard operating procedures to determine __________. The proper way to do a task GD&T __________. Allows certain tolerances on part features to be increased 1. Which type of feature is parallel to the surface being dimensioned? A. extension line B. dimension line ...

The number of defects produced is a measure of __________. The effectiveness of a quality assurance system A worker should __________ any time the worker notices a minor quality problem that is not critical to product function or performance. Notify the supervisor to determine the correct action ...

While on the production floor, what is audited? Measurement tool calibration One of the most important reasons for a checklist in an "in-process" audit is to Obtain relatively uniform results Consider the statement, "Even if corrective action is taken immediately for a finding during the au...

What happens when you eliminate quality variances? You Improved process quality. Spreadsheets are used to perform calculations in ____. Rows and columns Spreadsheets are used to form ___. graphs To make sure the appropriate parties are notified, use a __________. Predetermined distribution ...

The performance of the product as viewed by the consumer is ultimately the most important measure of __________. Product Quality Defect prevention is the __________ of the four types of quality cost. Most cost efficient It is __________ for workers to inspect and sort out defective products th...

Question: Of the four roles of management, controlling covers which of the following actions: Monitoring actual to standard work performance Question: The performance of the product as viewed by the customer is ultimately the most important measure of __________. Product quality Question: To r...

Which type of feature is parallel to the surface being dimensioned? Dimension line The three standard views of an object are __________. Top, front, right side Which type of lines are used to show the counterbored hole in the part? Hidden lines The number of views in a drawing __________. I...

What should a receiving inspector do if incoming material is found to be nonconforming? Reject the material Sampling plans are determined by Frequency chart When connected to a PC, a digital caliper can be used to Collect SPC data ECN stands for Engineering Change Notice Adjusting an ins...

A feature of all mistake-proofing systems is: Automated inspection Third-party audits provide evidence that a quality program meets standards. A Third-party audit might be performed in order to: Acquire or maintain certification An auditor bases his/her audit report on data collected by: Direc...

root cause the deficiency in a system that explains why a problem exists. Root Cause Failure Analysis (RCFA) the procedure to determine the cause of a defective product or a non conforming process Cause and Effect diagram a problem analysis tool used to identify the possible factors that affec...

The performance of the product as viewed by the customer is ultimately the most important measure of __________. Product quality To reduce variation, minimize defects, and to shorten cycle time are considered __________ goals. Quality Defect prevention is the __________ of the four types of qu...

Automated part inspection commonly uses __________. vision systems Parts labeled ______ should be inspected to determine if they should be reworked or scrapped. hold _____________ inspections assure that the equipment, personnel and processes being used are providing the desired results and al...

Quality A product meets/exceeds the expectations and the needs of the customer Quality Planning Designing a process that is capable of meeting quality standards Inspection An assessment activity that compares a specific product quality with a standard value; taking a measurement and comparing ...

1. Inspection data requires for making effective manufacturing decisions: Accurate data. 2. A feature of all mistake-proofing systems is: Automated inspection. 3. A manufacturer has several options to handle nonconforming materials. The option to use a nonconforming material is acceptable: Onl...