FOA CFOT EXAMS PACKAGE DEAL QUESTIONS AND ANSWERS WITH VERIFIED SOLUTIONS UPDATED 2024/25

In an electrical circuit the reverse current cut-out relay will open: a. when battery voltage exceeds generator voltage b. when circuit voltage is less than generator voltage c. when the main output CB is reset d. when the batteries are flat - ANSWER a A generator cut-out is provided: a. ...

Although metal water piping alone is not permitted to serve as a grounding electrode conductor the first ____ of metal water pipe entering the building is permitted to serve as part of the grounding electrode - ANSWER 5 feet What is the smallest size wire permitted to be used as a main bonding ju...

Which welding process is most often chosen for robotic arc welding? Select one: a.Submerged Arc Welding process. b.Gas Metal-Arc Welding process. c.Gas Tungsten Arc Welding process. d.Reverse Metal-Arc Welding process. - ANSWER b Which of the following terms describes spherical or tube like ...

a - ANSWER QUESTION A-1 With the reactor on a constant period, which transient requires the LONGEST time to occur? A reactor power change of: a. 5% of rated power - going from 1% to 6% power of rated power b. 10% of rated power - going from 10% to 20% power of rated power c. 15% of rated power -...

Technician A says that the torque available at the output shaft is greater in 2nd gear than when the transmission/transaxle is in 3rd gear at the same engine speed. Technician B says that the output shaft is rotating faster when the transmission/transaxle is in 2nd gear compared to 3rd gear when the...

one coulomb per second is equivalent to 1 A and 1 C is equal to 6.3 x 10^18 electrons. therefore, operation at 100 mA would result in a current of: - ANSWER 6.3 x 10^17 electrons/s the filament transformer: - ANSWER increases current located with the high-voltage generator, a step-down transfo...

MIS Chapter 1.1 mentions: Moore's Law Murphy's Law Parkinson's Law All of the above - ANSWER c Answer the following based on your reading in MIS Chapter 1.3. Which company provides cloud services to Netflix to stream its contents? IBM Apple

ARTICLE 215-FEEDERS QUESTIONS AND ANSWERS WITH SOLUTIONS 2024/25

Tubes used for high pressure boiler service are usually: Select one: a. welded b. rolled c. seamless d. beaded - ANSWER c This type of boiler is assembled piece by piece on the work site: Select one: a. field-assembled b. field-erected c. packaged d. auxiliary - ANSWER b A cylindr...

POWER ENGINEERING 4A2 CH51 DEVELOPMENT OF BOILER DESIGN QUESTIONS AND ANSWERS WITH SOLUTIONS 2024/25

b - ANSWER The ___________ must be permanently applied to the vessel. a) pressure b) nameplate c) seal d) signature a - ANSWER __________ _______ are leak proof containers that have an internal or external operating pressure. a) Pressure vessels b) Fired boilers c) F...

Which of the following devices measures ohms, amps, and volts - ANSWER Multimeter Which of the following devices is also called and insulation resistance tester - ANSWER Megometer Which instrument should be used to verify that there is power available to run a thiree-phase motor that will not ...

Programmable Logic Controllers: A) Are limited to doing only 1 thing at a time B) Have replaced pneumatic controls across industry C) Are common in industrial sites D) Are delicate instruments E) Are not expandable - ANSWER c HMI stands for: A) Human Mechanical Interferenc...

Courts consider evidence data in a computer as ____ evidence. a. physical b. invalid c. virtual d. logical - ANSWER a ISPs can investigate computer abuse committed by their customers. (t/f) - ANSWER false Real-time surveillance requires ____ data transmissions between a suspect's comput...

Describe the Type "Y" lighting fixtures shown on the site lighting plan. - ANSWER 400 W MH floodlight, ground mounted e16 On Panelboard Schedule MSB2, what is the size indicated for the feeder conduits? - ANSWER Seven 4" conduits E17 On the E2 lighting plan, Panelboard ? using Circuits ? suppl...

The gas pilot pressure regulator ________ the incoming header gas pressure, ensuring a satisfactory pilot flame. a. reduces b. increases c. controls d. samples - ANSWER a The main gas pressure regulator ________ the gas pressure at a higher setting than the pilot regulator. a. reduces b...

what is an industrial robot? - ANSWER general-purpose, programmable machine possessing certain anthropomorphic characteristics, the most obvious of which is a mechanical arm that is used to perform various industrial tasks. what are the five joint types used in robotic arms and wrists? - ANSWER...

What is the total load, in VA, for two small appliance branch circuits in a single-family dwelling? - ANSWER 3,000VA What is the maximum number of general-purpose noncontinuous duty duplex receptacles that can be connected to a 20A, 120V circuit in a commercial building? What is the NEC® require...

The yoke that supports the main components of the DC machine is frequently made of: Select one: a. Cast steel or iron b. Copper and carbon c. Aluminum d. Copper or brass e. Mica and carbon - ANSWER a The space around a magnet, through which the invisible magnetic lines of force are conside...

Watts - ANSWER What is a linear measure of optical power? Wavelength - ANSWER What is the measure of the color of light, usually expressed in nanometeres (nm) or microns (*m)? Wavelength Division Multiplexing (WDM) - ANSWER What do you call a technique of sending signals of several different w...

ASE Education Foundation - ANSWER What organization accredits automotive programs? ASE - ANSWER What organization certifies automotive technicians? franchises - ANSWER Carquest, NAPA, and Jiffy Lube are examples of: star pattern - ANSWER When torquing lug nuts on a vehicle, which pattern sh...

Transients are ? - ANSWER direct current overloads Feed through GFCI receptacles allows - ANSWER increased protection and quicker action SPD protection is necessary - ANSWER anywhere integrated electronic equipment circuits are installed Metal Oxide Varistors - ANSWER clamp transient voltag...

b - ANSWER Salient pole rotors: a) Are used on high speed alternators b) Are used on alternators not exceeding 1800 rpm c) Require no maintenance d) Are used on only single phase generators e) Are used on only three phase generators d - ANSWER Transformers function on the prin...

According to 46 CFR Part 113, what would be the maximum time delay period allowed for a ships steering system to reach a 15 degree right rudder helm order from midships, before an alarm condition will be indicated? a) 5 seconds b) 10 seconds c) 15 seconds d) 20 seconds - ANSWER b According to...

The main function of a gas burner is: A) Air flow control B) Provision of air fuel contact C) Atomization of the fuel D) A source of ignition E) Regulation of the fuel flow - ANSWER b If not enough air is given to an oil fired flame: A) The steam temperature will rise B...

Since cast iron has a high resistance to corrosion and abrasion, it is used for a) underground steam lines b) ash handling systems c) condensate lines d) blow-off piping e) high pressure service - ANSWER b Forged steel is used primarily for a) pipe fittings b) sewer lines c) steam l

15) In general, a data destination will be shown by A) an arrow pointing away. B) an arrow pointing in. C) arrows pointing both ways. D) no arrows, only two horizontal lines. - ANSWER b 16) In a data flow diagram of the customer payment process, "update receivables" will appear abov...

When isolating a steam turbine driven centrifugal pump you should first a) open the breaker b) close the turbine exhaust steam valve c) close the pump suction valve d) close the high pressure steam supply valve e) open the turbine casing drain - ANSWER d When isolating an electric motor d...

What is the main purpose of baffles in the setting of a boiler? a. To supply strength to the setting b. To allow hot gases to make more than one pass through a boiler c. To produce eddy currents d. To cause a restriction of gas flow e. to mix the fuel gas and the combustion air for complete com...

_____ on centrifugal air compressors are provided in order to control the amount of air flowing to the impeller and thus control the capacity of the unit. a. Adjustable inlet vanes b. Adjustable diffuser vanes c. Variable frequency drive d. Moving and fixed blades e. Dummy piston. - ANSWER a ...

b - ANSWER A frequent means of heating large facilities such as factories, warehouse and garages is to use a: a. Fin fan b. Unit heater c. Convector d. Radiator e. Space heater. e - ANSWER A radiator valve is used to control the amount of: a. Air leaving the radiator b. Condensate leaving...

If a sample of items is taken and the mean of the sample is outside the control limits, the process is: A) likely out of control and the cause should be investigated. B) in control, but not capable of producing within the established control limits. C) within the established control limits with o...

The code requirement of "an adequate supply of potable running water" is for ___. A) cleansing and sanitation B) protection of trap seals C) water-cooled equipment D) hydronic systems - ANSWER a The primary reason for installing backflow prevention assemblies is to ___. A) prevent ex...

(4-113-1.9) The two major types of compression refrigeration systems are: Select one: a. High pressure and low pressure b. Indirect and Direct c. Frosting and non-frosting d. commercial and residential - ANSWER b (4-114-1.6) Ammonia, as well as being toxic, is also: Select one: a. A low pr...

__________ refers to a computer network in which connections rely on radio waves at frequencies of 2.4 GHz or 5 GHz. Microwave transmission Digital subscriber lines (DSL) WiFi Optical fiber cables - ANSWER c A __________ typically consists of 8 bits. byte snip megabyte

What is involved in dressing a knot? Select one: a.Beginning with a temporary hitch b.Creating the bight to start the knot c.Untying the knot and straightening the rope d.Tightening the knot and removing slack - ANSWER d What is one disadvantage of synthetic fiber rope? Select one: a.Melts...

Which president put solar panels on the White House? - ANSWER Jimmy Carter Who took the solar panels off of the White House - ANSWER Ronald Reagan When was the solar transistor radio made? - ANSWER 1958 What is the primary drawback of solar power? - ANSWER the sun isn't always shining ...

DIGITAL WELLNESS QUESTIONS AND ANSWERS WITH SOLUTIONS 2024/25

Which of the following is the most important aspect of security? A. Physical security B. Intrusion detection C. Logical security D. Awareness training - ANSWER a What method can be used to map out the needs of an organization for a new facility? A. Log file audit B. Critical path anal...

AUTOMATION AND ROBOTICS VOCAB QUESTIONS AND ANSWERS WITH SOLUTIONS 2024/25

Briefly discuss panelboard installations that do not require a main protective device and then outline situations in which individual protection is required. - ANSWER Individual protection is required when the panelboards are connected to a secondary of a transformer that only has primary protection...

TURBOCHARGING QUESTIONS AND ANSWERS WITH SOLUTIONS 2025

OSHA 30 - construction focus 4 electrocution questions and answers with solutions 2025

CHAPTER 8 LAB questions and answers with solutions 2024/25

DIESEL AIRBRAKE SYSTEMS TEST 1 QUESTIONS AND ANSWERS WITH SOLUTIONS 2025

POWER ENGINEERING 4TH CLASS CH 86 QUESTIONS AND ANSWERS WITH SOLUTIONS 2025

POWER ENGINEERING 4TH CLASS CHAPTER 94 QUESTIONS AND ANSWERS WITH SOLUTIONS 2024/25

BUILDING CONSTRUCTION CHAPTER 6 REVIEW QUESTIONS AND ANSWERS WITH SOLUTIONS 2024/25

A320 HYDRAULIC SYSTEM QUESTIONS AND ANSWERS WITH SOLUTIONS 2024/25

DC CHAPTER 1 HOMEWORK BASIC CONCEPTS OF ELECTRICITY QUESTIONS AND ANSWERS WITH SOLUTIONS 2024/25

FIRE EXTINGUISHING SYSTEMS TEST 3 CH 9,10,11,12,13 QUESTIONS 2024/25

BIG THREE TEST QUESTIONS AND ANSWERS WITH SOLUTIONS 2024/25

CH 13 OVERALL AUDIT STRATEGY AND AUDIT PROGRAM QUESTIONS AND ANSWERS WITH SOLUTIONS 2024/25

HVAC UNIT 18 DEFINITIONS QUESTIONS AND ANSWERS WITH SOLUTIONS 2024/25

ASPE CPD study questions AH and answers with solutions 2024/25

PRESSURE questions and answers with solutions 2024/25

OSHA 30 hour study guide and answers with solutions 2024/25

POWERPLANT questions and answers with solutions 2024/25

RECTIFICATION questions and answers with solutions 2024/25

BUILDING SYSTEMS TEST 2 QUESTIONS AND ANSWERS WITH SOLUTIONS 2024/25

IET327 FINAL 3 QUESTIONS AND ANSWERS WITH SOLUTIONS 2024/25

CDL SECTION 5 AIR BRAKES QUESTIONS AND ANSWERS WITH SOLUTIONS 2024/25