100% Zufriedenheitsgarantie Sofort verfügbar nach Zahlung Sowohl online als auch als PDF Du bist an nichts gebunden
logo-home
Sewage Treatment Worker Practice Test Questions and Answers 100% Correct 10,45 €   In den Einkaufswagen

Prüfung

Sewage Treatment Worker Practice Test Questions and Answers 100% Correct

 52 mal angesehen  2 mal verkauft
  • Kurs
  • Sewage Treatment Worker
  • Hochschule
  • Sewage Treatment Worker

Sewage Treatment Worker Practice Test Questions and Answers 100% Correct Sewage Treatment Worker Practice Test Questions and Answers 100% Correct Sewage Treatment Worker Practice Test Questions and Answers 100% Correct Sewage Treatment Worker Practice Test Questions and Answers 100% Correc...

[ Mehr anzeigen ]

vorschau 2 aus 5   Seiten

  • 16. mai 2024
  • 5
  • 2023/2024
  • Prüfung
  • Fragen & Antworten
  • Sewage Treatment Worker
  • Sewage Treatment Worker
avatar-seller
Sewage Treatment Worker Practice Test Questions and Answers 100% Correct
The scale on the drawing is 1/8"=1. What is the actual length of a line that measures 2" 1/4' on the drawing? - ANSWER-6 ft? 18 ft?
Which of the following measure the specific gravity of the electrolyte of a wet cell battery? - ANSWER-Hydrometer
A possible cause for an air conditioner compressor to run continuously is a - ANSWER-
Defective low pressure control switch? Shortage of refrigerant?
Threads are cut in a rod by rotating the die stick 1/4 turn back for each 1/2 forward turn, this is done in order to? - ANSWER-Break the Chips
Three pumps are connected to a water tank, each pump pumps a rate of A=150 GPH B=250 GPH C=500 GPH, what is the average pumping rate of the pumps in gallons per hour? - ANSWER-300
If the capacity of the water tank is 14,250 gallons, how many hours will it take to fill the tank using only pumps B=250 GPH and C=500 GPH - ANSWER-19
What type of power tool uses the blades shown below? Diagram - ANSWER-
Reciprocating Saw
What is the length of pipe needed to make four pieces measuring 18 3/4", 8 1/8", 16 5/16", 24 1/2"? - ANSWER-67 11/16
The one of the following that is not on a glove valve is? - ANSWER-Wedge
An elbow having an outside thread on one end and inside thread on the other end is called - ANSWER-Street Elbow
When drilling cotter pin holes in a piece of round stock, the piece should be held with a -
ANSWER-V Block
The volume of the tank in cubic feet is D=10 ft, H=40 ft? - ANSWER-3,142 (3.14 x 5 squares x 40) How many gallons of paint will be needed to paint the inside of the above tank, (Assume
that one gallon of paint cover 100 sq. feet) Diameter is 10, Height is 40 - ANSWER-12?
14? How
The gauges in the above drawing represents the current reading of water meter in cubic
meters. If the previous reading was 1932, how much water has been used? Diagram is showing 9159 - ANSWER-7227
Which of the following power tools should be used for driving and removing nuts, bolts, studs, and screws? - ANSWER-Air impact gun
Of the following, the main reason for using lubricant is to - ANSWER-Reduce Friction
The order to prepare concrete using a 1:2:4 volumetric ratio, how much gravel and sand
should be mixed with 22 bags of cement? - ANSWER-44 cu. ft. and 88 cu. ft. of gravel
The SAE numbers of an oil refer to its - ANSWER-Viscosity
The least important factor when determining a suitable viscosity for a bearing lube is the
- ANSWER-Location of bearing? Operating speed?
Which of the following tools should be used when finishing a surface? - ANSWER-
Orbital Sander
What is the capacity of this tank, 20'wide, 40' long, and 10' high - ANSWER-8000 (multiply them all)
What is the area of the base of the above tank in sq. ft? - ANSWER-800 (Length x width)
The knot that should be used when joining 2 lines of different thicknesses? - ANSWER-
Sheet Bend
A method of joining 2 overlapping plates by drilling a hole and filling the hole with metal is? - ANSWER-Plug Weld
Why should a centrifugal pump be primed before starting it up? - ANSWER-To remove Air
Which of the following tools would give the most accurate measurement of the diameter of the shaft? - ANSWER-Outside micrometer
Which of the following is the function of the impeller wear ring? - ANSWER-Physically separate the high and low pressure zones
What is the minimum angle a ladder should be placed from the wall? - ANSWER-25%

Alle Vorteile der Zusammenfassungen von Stuvia auf einen Blick:

Garantiert gute Qualität durch Reviews

Garantiert gute Qualität durch Reviews

Stuvia Verkäufer haben mehr als 700.000 Zusammenfassungen beurteilt. Deshalb weißt du dass du das beste Dokument kaufst.

Schnell und einfach kaufen

Schnell und einfach kaufen

Man bezahlt schnell und einfach mit iDeal, Kreditkarte oder Stuvia-Kredit für die Zusammenfassungen. Man braucht keine Mitgliedschaft.

Konzentration auf den Kern der Sache

Konzentration auf den Kern der Sache

Deine Mitstudenten schreiben die Zusammenfassungen. Deshalb enthalten die Zusammenfassungen immer aktuelle, zuverlässige und up-to-date Informationen. Damit kommst du schnell zum Kern der Sache.

Häufig gestellte Fragen

Was bekomme ich, wenn ich dieses Dokument kaufe?

Du erhältst eine PDF-Datei, die sofort nach dem Kauf verfügbar ist. Das gekaufte Dokument ist jederzeit, überall und unbegrenzt über dein Profil zugänglich.

Zufriedenheitsgarantie: Wie funktioniert das?

Unsere Zufriedenheitsgarantie sorgt dafür, dass du immer eine Lernunterlage findest, die zu dir passt. Du füllst ein Formular aus und unser Kundendienstteam kümmert sich um den Rest.

Wem kaufe ich diese Zusammenfassung ab?

Stuvia ist ein Marktplatz, du kaufst dieses Dokument also nicht von uns, sondern vom Verkäufer NursingTutor1. Stuvia erleichtert die Zahlung an den Verkäufer.

Werde ich an ein Abonnement gebunden sein?

Nein, du kaufst diese Zusammenfassung nur für 10,45 €. Du bist nach deinem Kauf an nichts gebunden.

Kann man Stuvia trauen?

4.6 Sterne auf Google & Trustpilot (+1000 reviews)

45.681 Zusammenfassungen wurden in den letzten 30 Tagen verkauft

Gegründet 2010, seit 14 Jahren die erste Adresse für Zusammenfassungen

Starte mit dem Verkauf
10,45 €  2x  verkauft
  • (0)
  Kaufen