100% tevredenheidsgarantie Direct beschikbaar na je betaling Lees online óf als PDF Geen vaste maandelijkse kosten
logo-home
Pearson BTEC Business $27.31
In winkelwagen

Tentamen (uitwerkingen)

Pearson BTEC Business

 0 keer verkocht
  • Vak
  • Instelling
  • Boek

Exam study book Operations Management of Nigel Slack, Alistair Brandon-Jones - ISBN: 9781292253961, Edition: 9, Year of publication: - (it is a summary)

Voorbeeld 2 van de 7  pagina's

  • 29 november 2021
  • 7
  • 2021/2022
  • Tentamen (uitwerkingen)
  • Vragen en antwoorden
avatar-seller
Cambridge International Examinations
Cambridge International Advanced Subsidiary and Advanced Level



MATHEMATICS 9709/13
Paper 1 October/November 2016
MARK SCHEME
Maximum Mark: 75




Published



This mark scheme is published as an aid to teachers and candidates, to indicate the requirements of the
examination. It shows the basis on which Examiners were instructed to award marks. It does not indicate the
details of the discussions that took place at an Examiners’ meeting before marking began, which would have
considered the acceptability of alternative answers.

Mark schemes should be read in conjunction with the question paper and the Principal Examiner Report for
Teachers.

Cambridge will not enter into discussions about these mark schemes.

Cambridge is publishing the mark schemes for the October/November 2016 series for most
Cambridge IGCSE®, Cambridge International A and AS Level components and some Cambridge O Level
components.




® IGCSE is the registered trademark of Cambridge International Examinations.


This document consists of 7 printed pages.

© UCLES 2016 [Turn over

, Page 2 Mark Scheme Syllabus Paper
Cambridge International AS/A Level – October/November 2016 9709 13

Mark Scheme Notes

Marks are of the following three types:

M Method mark, awarded for a valid method applied to the problem. Method marks are not lost
for numerical errors, algebraic slips or errors in units. However, it is not usually sufficient for a
candidate just to indicate an intention of using some method or just to quote a formula; the
formula or idea must be applied to the specific problem in hand, e.g. by substituting the
relevant quantities into the formula. Correct application of a formula without the formula being
quoted obviously earns the M mark and in some cases an M mark can be implied from a
correct answer.

A Accuracy mark, awarded for a correct answer or intermediate step correctly obtained.
Accuracy marks cannot be given unless the associated method mark is earned (or implied).

B Mark for a correct result or statement independent of method marks.

• When a part of a question has two or more “method” steps, the M marks are generally
independent unless the scheme specifically says otherwise; and similarly when there are several
B marks allocated. The notation DM or DB (or dep*) is used to indicate that a particular M or B
mark is dependent on an earlier M or B (asterisked) mark in the scheme. When two or more
steps are run together by the candidate, the earlier marks are implied and full credit is given.

• The symbol implies that the A or B mark indicated is allowed for work correctly following on
from previously incorrect results. Otherwise, A or B marks are given for correct work only. A and
B marks are not given for fortuitously “correct” answers or results obtained from incorrect
working.

• Note: B2 or A2 means that the candidate can earn 2 or 0.
B2/1/0 means that the candidate can earn anything from 0 to 2.

The marks indicated in the scheme may not be subdivided. If there is genuine doubt whether a
candidate has earned a mark, allow the candidate the benefit of the doubt. Unless otherwise
indicated, marks once gained cannot subsequently be lost, e.g. wrong working following a correct
form of answer is ignored.

• Wrong or missing units in an answer should not lead to the loss of a mark unless the scheme
specifically indicates otherwise.

• For a numerical answer, allow the A or B mark if a value is obtained which is correct to 3 s.f., or
which would be correct to 3 s.f. if rounded (1 d.p. in the case of an angle). As stated above, an A
or B mark is not given if a correct numerical answer arises fortuitously from incorrect working. For
Mechanics questions, allow A or B marks for correct answers which arise from taking g equal to
9.8 or 9.81 instead of 10.




© UCLES 2016

Dit zijn jouw voordelen als je samenvattingen koopt bij Stuvia:

Bewezen kwaliteit door reviews

Bewezen kwaliteit door reviews

Studenten hebben al meer dan 850.000 samenvattingen beoordeeld. Zo weet jij zeker dat je de beste keuze maakt!

In een paar klikken geregeld

In een paar klikken geregeld

Geen gedoe — betaal gewoon eenmalig met iDeal, creditcard of je Stuvia-tegoed en je bent klaar. Geen abonnement nodig.

Direct to-the-point

Direct to-the-point

Studenten maken samenvattingen voor studenten. Dat betekent: actuele inhoud waar jij écht wat aan hebt. Geen overbodige details!

Veelgestelde vragen

Wat krijg ik als ik dit document koop?

Je krijgt een PDF, die direct beschikbaar is na je aankoop. Het gekochte document is altijd, overal en oneindig toegankelijk via je profiel.

Tevredenheidsgarantie: hoe werkt dat?

Onze tevredenheidsgarantie zorgt ervoor dat je altijd een studiedocument vindt dat goed bij je past. Je vult een formulier in en onze klantenservice regelt de rest.

Van wie koop ik deze samenvatting?

Stuvia is een marktplaats, je koop dit document dus niet van ons, maar van verkoper kushkadhyan. Stuvia faciliteert de betaling aan de verkoper.

Zit ik meteen vast aan een abonnement?

Nee, je koopt alleen deze samenvatting voor $27.31. Je zit daarna nergens aan vast.

Is Stuvia te vertrouwen?

4,6 sterren op Google & Trustpilot (+1000 reviews)

Afgelopen 30 dagen zijn er 65040 samenvattingen verkocht

Opgericht in 2010, al 15 jaar dé plek om samenvattingen te kopen

Begin nu gratis

Laatst bekeken door jou


$27.31
  • (0)
In winkelwagen
Toegevoegd