WIRING OF ONE LAMP
Exp.No:4
Name : Date:
Class and Batch: Roll no:
Batch mates’ no: Lab in Charge:
OBJECTIVE
To prepare an estimate and wire up the circuit of one lamp controlled by one switch.
TOOLS REQUIRED
Screw Driver, Line tester, Combination plier, Poker, Hammer, Wire stripper, Pen
Knife.
PROCEDURE
1. Draw the layout on the board.
2. Fix the conduit as per the lay out using saddles.
3. Draw the wires through the conduit according to the wiring diagram.
4. After taking wires through the holes, fix the round block and switch box.
5. Give the connections to lamp holder and switch.
6. Insert the Fuse and Neutral link.
7. Test the circuit.
1
Exp.No:4
Name : Date:
Class and Batch: Roll no:
Batch mates’ no: Lab in Charge:
OBJECTIVE
To prepare an estimate and wire up the circuit of one lamp controlled by one switch.
TOOLS REQUIRED
Screw Driver, Line tester, Combination plier, Poker, Hammer, Wire stripper, Pen
Knife.
PROCEDURE
1. Draw the layout on the board.
2. Fix the conduit as per the lay out using saddles.
3. Draw the wires through the conduit according to the wiring diagram.
4. After taking wires through the holes, fix the round block and switch box.
5. Give the connections to lamp holder and switch.
6. Insert the Fuse and Neutral link.
7. Test the circuit.
1
