Exam (elaborations)
Professional Home Inspector Exam NHIE / TREC / 2022
- Course
- Institution
Professional Home Inspector Exam NHIE / TREC / 2022
[Show more]
Seller
Follow
Welch1
Reviews received
Content preview
Professional Home Inspector ExamNHIE / TREC / 2022
The inspector is not required to determine ____ ___ of any system or component.
ANS:- -Years of age
-Life expectancy
-Make model
Horizontal waste pipe should slope ____ inch per foot
ANS:- 1/4" per foot if < 3 inch pipe.
1/8" per foot if > or = to 3 inch pipe
Drip screed ANS:- Also called weep screed.
Used at the base/bottom of stucco walls to release moisture.
Pressure Vacuum Breaker (PVB) ANS:- Used for Backflow Prevention.
Lawn Irrigation systems: installed vertically 6 to 12 inches above highest
outlet/emitter and before the irrigation system valves.
Lintel ANS:- L shaped steel installed to support brick veneer above openings such as
windows and doors.
Should bear on 6 inches or greater of the supporting veneer.
Rusted lintels may expand and cause cracks around openings.
Guardrail for decks and patios ANS:- A deck 30" above grade requires a guardrail.
Required if deck is > or = to 30 inches above grade.
Balusters and openings should not exceed 4 inches in diameter.
Rail height must be > or = to 36 inches from deck.
Minimum overlap on vertically installed fiber cement siding ANS:- 1 1/4 inches
overlap, and blind nailing recommended
Distance required between wall cladding and roof covering materials? ANS:- 1" to 2"
(1 inch minimum, some local code is 2")
What is the concern with a Double sided key lock deadbolt ANS:- All means of
egress (escape), must be operable from the inside without special knowledge or
tools. A keyed lock is a danger.
Fiberglass shingle roof that is 5 years old is losing granular and cupping. Attic
insulation and venting is adequate. What is the most reasonable explanation?
,ANS:- Improper installation. Sealing strip or nailing was not done properly.
What is the last part to fail in a slate roof system? ANS:- The slate itself. Flashings
eventually wear out, but long before the slate.
Metal roof has minor rust in spots. What is the corrective action? ANS:- Removing
the rust, priming and painting.
What type of flashing is found on a gable edge? ANS:- Rake edge or edge flashing.
A gable Edge is called a rake.
Which construction framing provides fire blocking? ANS:- a platform-framed structure
The Bottom chords of trusses were cut to fit other construction. What is the
recommendation? ANS:- Recommend a structural engineer .
What purpose does a barometric damper serve? ANS:- To control the draft
Water is dripping from discharge piping coming from a hydronic heating system.
What is most likely the cause? ANS:- A leak
Masonry Chimney is required to be _____ inches from wood framing in the attic?
ANS:- 2"
When new insulation is placed directly over old in the attic, what is the correct way to
place / handle Kraft paper on new insulation? ANS:- Score or remove the vapor
paper
What two structural components would be tied together with hurricane ties? ANS:-
Truss/rafter to the top of walls
What type of piping is used for a pool circulation system? ANS:- Schedule 40 PVC
Does the main water supply shutoff have to be above grade, below grade, or
accessible? ANS:- Accessible
Distance between interior electrical receptacles? ANS:- 12'
A wood burning furnace should be how far away from combustibles ANS:- 18"
Dishwasher drain line is installed where in reference to the trap? ANS:- Above
stairs, staircase tread depth ANS:- Tread depth should be a minimum of 10 inches.
11 inches if there is no nosing.
,The difference between any two riser heights, treads or nosing in a flight of stairs
should be no more than 3/8ths of an inch
Staircase Nosing projection ANS:- Nosing should project between 3/4th inch and 1
1/4th inch
The difference between any two riser heights, treads or nosing in a flight of stairs
should be no more than 3/8ths of an inch
Staircase Riser height ANS:- Riser height should be 7 3/4th inches maximum
The difference between any two riser heights, treads or nosing in a flight of stairs
should be no more than 3/8ths of an inch
Stair stringers and width ANS:- Stairs wider than 36 inches should have at least
three stringers
Spiral staircase ANS:- Tread depth should be a minimum of 7 1/2 inches, measured
12 inches from the narrow side.
Riser height should be 9 1/2 inches maximum.
Minimum width is 26 inches at / below the handrail
Hearth size requirements for greater than and smaller than 6 square feet ANS:- 6'
opening - 16" in front and 8" sides
Over 6' - 20" and 12"
What is a cricket or saddle? ANS:- A ridge structure designed to divert water on a
roof around the high side of a chimney or the transition from one roof area to another
Deadman ANS:- any type of anchor embedded in the supported soil and tied to the
retaining wall
Egress window ANS:- A window large enough, as defined by local building codes, for
exit or entry in case of an emergency. Typically required in bedrooms.
Size:
Height above floor:
Which roof covering would be best for a slope of 2 inches per foot? ANS:- 2:12 is
minimum for asphalt. Recommend metal roof.
Foundation anchor bolts shall be at least ___ inch in diameter and shall extend a
minimum of ___ inches into the concrete or grouted cells of concrete masonry units.
ANS:- 1/2 and 7 inches
, Foundation anchors should be ___ from ends and ___ apart/between. ANS:- 4-12
inches and 6 feet
Floor joists are installed with the crown facing which direction? ANS:- Up
Grounding electrode should be a minimum of ___ feet below grade ANS:- 8'
A window in a shower requires safety glazing if the bottom is ___ inches above the
shower pan. ANS:- Less than 60" in any bathing/swimming area
Safety glazing is required where ANS:- Panes larger than 9 square feet if all the
following are true:
Bottom less than 18" from floor
Top edge over 36" from floor
Walkway within 36" of glazing
The shower opening (or access and egress opening) should be at least _____ finish-
width and ___ inches unobstructed in front of the door. ANS:- 22 inches wide
opening, and 24 horizontal inches in front of door
Also, the door should always open outward or OK if it opens both in and out.
Swale ANS:- A graded flow path used in open drainage systems.
Non-Metallic Sheathed Cable (NM) ANS:- _________ is a factory assembly of two or
more insulated conductors having an outer sheath of moisture resistant flame-
retardant, non-metallic material.
Commonly called Romex.
Should be supported every 4 1/2 feet, and within 1 foot of boxes and terminations.
Should have a nail guard when run closer than 1 1/4 inches from framing members.
What is the Temperature on the large refrigerant line when AC is in cool mode?
ANS:- Cool. The large (Suction) line should be cool, low pressure, returning to the
condenser outside.
Underground feeder (UF) ANS:- Similar to Nonmetallic sheathed cable (NM), but UF
is Designed for wet locations and may be buried.
Compressor does what? ANS:- Compresses cool gas to superheated high pressure
gas to send through the condenser.
Condenser does what? ANS:- The condenser takes high pressure heated gas from
the compressor, and runs the gas through coils where the fan helps remove heat
from the gas, and resulting in a warm, high pressure liquid to return to the
evaporator.
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller Welch1. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $7.99. You're not tied to anything after your purchase.
Can Stuvia be trusted?
4.6 stars on Google & Trustpilot (+1000 reviews)
79276 documents were sold in the last 30 days
Founded in 2010, the go-to place to buy study notes for 14 years now