NCCER Module 9 Introduction to Materials Handling Already Passed

NCCER Module 9 Introduction to Materials Handling Already Passed What is the proper procedure to lift objects? Lift with your legs, keep your back straight, and keep your head up. In order to work with motorized materials-handling equipment, you must be? trained, certified, and authorized Before attempting to lift any material, you should look for any? protruding nails, wires, or sharp edges Before attempting to lower and overhead load,________. Consider the size of the load. When stacking bags of material that are the same width, step back and cross key the bags________. At least every 10 bags high When moving a material cart on an inclined or declined surface, you must be sure the load does not exceed the labeled __________capacity. weight Never stack or store materials_______. On scaffolds When using hand signals, you must always keep __________contact with the operator. eye The knot shown in the figure above is a ___________. Clove hitch One common way to tie a clove hitch os to use two___________. Half hitches How is the fall zone for a fork lift operation best defined? The area the materials could possibly fall. What device may have a rotating table surface and/or spikes on the table surface for a better grip? Roller skids To transport a bottle of compressed gas, use a________. Cylinder cart To prevent a tip over when driving a rough terrain forklift, keep the load________. Low The forklift hand signal for dog everything means___________. Pause