MSSC Quality Practices & Measurement Questions and Answers Already Passed

MSSC Quality Practices & Measurement Questions and Answers Already Passed Which type of feature is parallel to the surface being dimensioned? Dimension line The three standard views of an object are __________. Top, front, right side Which type of lines are used to show the counterbored hole in the part? Hidden lines The number of views in a drawing __________. Is the fewest number that shows all of the features and dimensions Which of the following steps is NOT used in the glass box method? Rotate object in glass box. What type of drawing is shown? Multiview The dimensions of raw material supplied by metal suppliers are described by the __________. Stock size Which of these requires a computer? CAD An isometric drawing is a type of __________. Pictorial drawing In the graphic shown, the two circles are __________. Concentric Dimensions are used to specify the __________ and location of the features of an object. Size What feature in the figure shown is a Chamfer? D A __________ dimension is described in inches per foot. Shaft taper What is the order of precedence of lines in a drawing? Object, Hidden, Center Which of the following is not one of the six rules for dimensioning an object? Dimension hidden lines Engineers sometimes use a __________ to measure angles on a drawing. Protractor What dimension is indicated in this graphic? Height There are 60 minutes of arc in one __________. Degree In manufacturing, a blueprint is also called what? A technical drawing The distance across the flats of the hex head shown in the part drawing is __________ inches. 2 ¼ The length of the part shown in the drawing is __________ inches. 9 ¾ Which type best describes the line indicated in the graphic? Object Line Which of the following bolts is a grade 2? A The