Elevator Mechanic Study 278|questions with 100%verified answers

Elevator Mechanic Study 278 Elevator Mechanic Study 278 Its a box with shaded triangle in lower right hand corner. answer- Which relay do you need to Order 710 Pg, 7 RPM = 60 ∙ ƒ ÷ P÷2 = Step 1. 60 x Frequency (Hz.) = Step 2. Poles ÷ 2 = Take answer 1 and ÷ by answer 2 = answer- Know the formula for RPM 435 Pg. 5 If you are referring to a megohm meter, it is a test of the insulation properties of such things as electric wiring, motor windings and high power antenna mounts. We use a "megger" or "meg out" electrical wiring and equipment to see if it is shorted to ground or the frame in any way. The megger uses much higher voltages to check resistance than a normal Volt-ohm meter. Minimum resistance is 1 Meg Ohm answer- Know what a Megger is and what it does 636 Pg. 13 (1) A parallel connection. (2) A resistive element placed across the terminals of an armature to bypass a portion of the current. (3) A flexible electrical conductor designed to conduct current around the mechanical joint between two conductors. (4) The resistive element (Usually of very low resistance) used in parallel with a DC ammeter movement to bypass a calibrated portion of the total circuit current. answer- Shunt Overloads 425 All Pages Bad Ground answer- You are using a Temp Run Box and you get shocked! Why! 520 Pg. 4 The bridle hitch can consist of two,three, or four single hitches (fig. 3-22), used together to form a bridle hitch for hoisting an object A sling with two legs used to lift a 1,000 pound object will have 500 pounds of the load on each leg when the sling angle is 90 degrees. The load stress on each leg increases as the angle decreases; and if the sling angle was 30 degrees lifting the same 1,000