NCCER Electrical Level 1 Mod 1 Orientation to the Electrical Trade Study 2023/2024

NCCER Electrical Level 1 Mod 1 Orientation to the Electrical Trade StudyThe NCCER electrical training program applies DOL standards and is a four-year program Entry into an apprenticeship program is likely to require a(n) GATB Form Test The minimum standards for the safe installation of electrical systems can be found in the National Electrical Code (NEC) OSHA standards for general industry are covered in 29 CFR, Parts The termination of devices and fixtures is completed during a construction phase known as trim-out Which of the following is true with regard to commercial electrical work? fire alarm systems are commonly required. In industrial facilities, the electrical systems are most likely maintained by on-site maintenance personnel Employers of commercial electricians are generally electrical contractors who work as subcontractors for general contractors Interior panels in residential wiring are typically installed during rough-in A residential wiring system typically uses nonmetallic-sheathed cable Commercial wiring is typically installed in metal raceways Which of the following would most likely require special knowledge of hazardous locations? Industrial wiring Tract homes are typically wired by residential electrician Minimum standards for apprentice training programs are established by the DOL Which of the following is true with regard to your apprenticeship? licensing requirements vary from state to state Which of the following is true with regard to tardiness and absenteeism? if you must be absent, call in early so that your employer can find a replacement If you see a safety violation at your job site, you should report it to your supervisor The primary mission of OSHA is to ensure that employers maintain a safe workplace is the federal government agency established to ensure a safe and healthy environment in the workplace. OHSA Job-related learning acquired while working is known as On-the-job learning (OJL) The main panelboard enclosure would probably be installed in the _______________ stage.