Electrical Safety in the Workplace Correct Questions & Answers!!

What is the purpose of the Occupational Safety and Health Act? - ANSWER The ensure the establishment of safe and healthy working environments. Electrical Safety in the Workplace p.5 The NFPA 70E has a supplemental section which contains... - ANSWER NEC articles Electrical Safety in the Workplace p.7 What is an explosive event that occurs with an arc flash? - ANSWER an arc blast Electrical Safety in the Workplace p.8 The NFPA70E applies to any workplace that had the potential for electrical hazards. Some examples are... - ANSWER office buildings, warehouses, and similar structures. Electrical Safety in the Workplace p.10 The terms "shall" and "shall not" in the NFPA 70E indicate... - ANSWER a mandatory rule Electrical Safety in the Workplace p.12 Arc flash suits are rated depending on... - ANSWER the amount of exposure a worker may experience during a flash. Electrical Safety in the Workplace p.19 What is energy released during an arc flash or any other arc situation? - ANSWER incident energy Electrical Safety in the Workplace p.21 What is the point at which the electric company wiring connects to a structure's wiring? - ANSWER Service point Electrical Safety in the Workplace p.23 What is it called when something is isolated by a fence or other structure to restrict access? - ANSWER Enclosed Electrical Safety in the Workplace p.25 An ungrounded conductor is normally referred to as the... - ANSWER hot conductor. Electrical Safety in the Workplace p.27-28 Who assumes responsibility for ensuring employee safety? - ANSWER Both the host and contract employer. Electrical Safety in the Workplace p.36 A qualified person must know how to... - ANSWER Conduct an analysis to assess the level of electrical hazard. Electrical Safety in the Workplace p.39 The hazard identification and risk assessment procedure should determine information associated with a hazard, such as... - ANSWER PPE needed to reduce injury Electrical Safety in the Workplace p.43 How often must an electrical safety audit be performed? - ANSWER At least every 3 years. Electrical Safety in the Workplace p.45 Appliances and portable tools have a CAT rating of... - ANSWER CAT II Electrical Safety in the Workplace p.45 The best possible way to prevent electrical shock or arcing is to... - ANSWER de-energize Electrical Safety in the Workplace p.53 What is the sixth step to achieve an electrically safe work condition? - ANSWER To ground devices when there is a possibility of stored electrical energy. Electrical Safety in the Workplace p.55 Until all required steps are completed, electrical hazards exist and... - ANSWER PPE must be worn Electrical Safety in the Workplace p.56 What is the procedure when a single disconnect controls the circuit or conductors on which work is being performed? - ANSWER simple lockout/tagout procedure Electrical Safety in the Workplace p.60 To tagout a device, nylon cable ties must be able to withstand ______ lbs of force. - ANSWER 50 Electrical Safety in the Workplace p.62 When is it acceptable to perform energized work? - ANSWER When removing power to create a safe work condition would create an even greater hazard, such as removing power from life-support equipment or emergency alarm systems.