4th Class ABSA Exam Part A Practice Questions And Answers Solved 100% Correct!!
1 view 0 purchase
Course
ABSA
Institution
ABSA
4th Class ABSA Exam Part A Practice Questions And Answers Solved 100% Correct!!
Absolute pressure is:
gauge pressure plus atmospheric pressure
The motion of moving parts is _____ by friction:
A: Prevented
B: Improved
C: controlled
D: resisted
E: Regulated
D: resisted
Voltage is
a) th...
4th Class ABSA Exam Part A Practice Questions And
Answers Solved 100% Correct!!
Absolute pressure is:
gauge pressure plus atmospheric pressure
The motion of moving parts is _____ by friction:
A: Prevented
B: Improved
C: controlled
D: resisted
E: Regulated
D: resisted
Voltage is
a) the rate of current flow
b) the rate of electron flow
c) electromotive force
d) Kinetic energy
e) A form of power
c) electromotive force
The resistance of a conductor is affected by:
1. Cross section area
2. Length
3. Temperature
4. Type of material
a) 1,2,3
b) 1,2,4
c) 1,3
d) 1,2,3,4
e) 1,2
d) 1,2,3,4
The movement of electrons in a conductor can be measured in:
a) Amperes
b) Ohms
c) Volts
d) Watts
e) Micrometer
a) Amperes
An electric motor has a 3/4 horse power output rating. Calculate the rating in
kilowatts:
a) 0.56
,b) 0.75
c) 0.70
d) 7.5
e) 1.005
a) 0.56
The connection provided on DC motors to supply the armature with power:
a) are slip rings
b) are field poses
c) is a rheostat
d) commutator
e) is a rotating conductor
d) commutator
The unit for the oppostion to current flow is the:
a) volt
b) amperes
c) ohm
d) watt
e) resistance
c) ohm
In an electric circuit protected by a single fuse the current flowing through the
fuse must be:
a) Equal to the voltage in the circuit
b) Equal to the resistance in the circuit
c) All of the current in the circuit
d) Equal to the rated value of the fuse
e) 1.732 times the applied current
d) Equal to the rated value of the fuse
Electric overloads may be due to
1. Applying too heavy load to an electric motor
2. Lightning strike
3. A short circuit
4. Overloading a circuit with too many devices
5. Addition of circuit breakers
a) 1,2,3,4
b) 1,3,4,5
c) 1,2,5
d) 2,3,4
e) 1,3,5
a) 1,2,3,4
Since the discovery of electrons, it has been determined that electrons are a
negative charge and flow from:
,Select one:
a. positive to negative
b. north to south
c. south to north
d. a lower potential to a higher potential
e. a higher potential to a lower potential
d
The yoke that supports the main components of the DC machine is frequently
made of:
a) Copper or brass
b) Mica and carbon
c) Copper and carbon
d) Cast steel or iron
e) Stainless steel
d
Electrical current flow through a conductor is caused by the drift of:
a) Photons
b) Neutrons
c) Electrons
d) Proteins
e) Protons
c
A device used to change the voltage and current from one level to another is
known as:
a) Conductor
b) Resistor
c) Alternator
d) Transformer
e) Shunt
d
Three resistances of 4, 8, 12, Ohms are connected in parallel in a DC circuit. The
total resistance in the circuit will be:
a) 24 ohms
b) 12 ohms
c) 0.58 ohms
d) 0.46 ohms
e) 2.18 ohms
e
A thermocouple consists of:
Select one:
a. A filament that is compared to the object being measured
b. Two dissimilar wires connected together
, c. Two dissimilar wires connected to a battery
d. Two similar wires separated by another metal
e. Two dissimilar wires connected to a computer
b
The electrical resistance of the conductor on a strain gauge will increase when a
tensile force is applied because the wire grid of the strain gauge will:
a) Decrease in length and cross-sectional area
b) Increase in length and cross-sectional area
c) Decrease in length
d) Increase in length and decrease in cross-sectional area
e) Decrease in cross-sectional area
d
Modulating combustion controls:
a) regulate the steam and feedwater supply
b) Regulate the fuel and air supply
c) Control the oil atomizer
d) Control the back draft damper
e) Modulate the water supply proportional to the air supply
b
A pyrometer is used to measure:
a) specific gravity
b) Temperature
c) Viscosity
d) The composition of flue gases
e) sensible heat
b
Which of the following controls would you expect to find on a hot water control?
1. Low water fuel cut-off
2. Operating temperature control
3. High limit pressure control
4. High limit temperature control
a) 1, 2, 4
b) 2, 3, 4
c) 1, 2, 3
d) 1, 3, 4
e) 3, 4
a
ASME Section IV requires that hot water heating boilers must be equipped with a
a) thermometer
b) fusible plug
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller QUICKEXAMINER. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $23.49. You're not tied to anything after your purchase.
