Tooling U Fasteners Questions and Answers Graded A+

Tooling U Fasteners Questions and Answers Graded A+ What is an advantage of adhesive bonding? Adhesive bonding: Can join a wide range of materials. Which of the following would an assembler do on an ideal automated assembly line? Monitor operations Which assembly method uses nonmetallic materials such as pastes, glues, or tapes? Adhesive bonding What process typically must be performed on adherents before they can be joined by adhesive bonding? Priming What is a disadvantage of mechanical fastening? Mechanical fastening requires: Precisely aligned components. Which of the following is a disadvantage of manual assembly lines? Labor costs Which assembly process creates delicate joints such as those found in jewelry? Soldering Which type of fastener can mate with corresponding threaded parts? Nut Which of the following is a common pneumatic tool used during mechanical fastening? Nail gun Which assembly method is used most in assembly? Mechanical fastening What is a disadvantage of welding? Welded joints: Are difficult or impossible to disassemble. Which type of automated assembly machine is commonly used for higher part counts? In- line index machine A continuous-drive clutch screwdriver used for repetitive, precise torque applications on hard joints is a: Automatic-shutoff screwdriver. A device that controls when the main motor receives power is called a: Clutch. A major advantage of electric tools is that they: Operate quietly and cleanly. A major advantage of pneumatic tools is that they: Have a high power-to-weight ratio. A soft joint differs from a hard joint because a soft joint requires: Two or more rotations to reach torque. A type of discontinuous-drive clutch tool often used to tighten lug nuts on a tire is a(n): Impact wrench. A type of hand screwdriver that has two intersecting perpendicular slots is a: Phillips screwdriver. A type of hand wrench that has jaws on both ends is a(n): Open-end wrench. A type of tool that shuts off its motor once it reaches torque is a(n): Continuous-drive tool. A type of tool used for large-scale construction that yields little or no torque reaction is a(n): Pulse tool. The type of assembly line that contains different models within the same line is the: Mixed- model assembly line. Which of the following is NOT an ergonomic concern when using fastener tools? Air compressor type. Which statement about battery-powered tools is true? Battery-powered tools: Have a poor power-to-weight ratio.