Garantie de satisfaction à 100% Disponible immédiatement après paiement En ligne et en PDF Tu n'es attaché à rien
logo-home
Hvac Journeyman Exam $9.99
Ajouter au panier

Examen

Hvac Journeyman Exam

 0 fois vendu
  • Cours
  • Établissement

Hvac Journeyman Exam Defects on gas piping or fittings shall be _____.(A) repaired(B) replaced or repaired and retested(C) repaired by a certified welder(D) ignored, as the operating pressure is much less than the air test. - B. Fitting shall be replaced or repaired and retested. UMC Section 1...

[Montrer plus]

Aperçu 3 sur 19  pages

  • 25 avril 2024
  • 19
  • 2023/2024
  • Examen
  • Questions et réponses
avatar-seller
Hvac Journeyman Exam
Defects on gas piping or fittings shall be _____.(A) repaired(B) replaced or repaired and

retested(C) repaired by a certified welder(D) ignored, as the operating pressure is much less than

the air test. - ✔✔B. Fitting shall be replaced or repaired and retested. UMC Section 1316.4.3



Every absorption refrigerating system supported from the ground shall rest on a concrete slab

extending not less than _____ the adjoining ground level.(A) 3 inches below(B) 3 inches above

(C) 6 inches below(D) 6 inches above. - ✔✔B. Slab extending not less than 3" above the

adjoining ground level. UMC Section 1106.2



Any part of a venting system installed at an angle greater than 45 degrees from the vertical is

considered by code to be _____.(A) vertica(B) horizontal l (C) a flat vent (D) an offset vent -

✔✔B. any part of the venting installed at an angle GREATER than 45 degrees is considered by

this code to be Horizontal UMC Section 802.6.1.1



Listed transition ducts f or clothes dryers shall not exceed_____ feet in length. A.3 B.4 C.5 D.6. -

✔✔D. Dryers shall not exceed 6 feet in length. UMC Section 504.3.2.1



Industrial product-conveying ducts and their fittings for abrasive and nonabrasive dust or solid

materials shall be constructed of _____.(A) sheet meta(B) polyvinyl chloride l (C) fiberglass (D)

A and C apply - ✔✔A. Shall Be Constructed of sheet metal. UMC Section. 5 0 6.1

,Industrial product-conveying ducts and their fittings for abrasive and nonabrasive dust or solid

materials shall be constructed of _____.(A) sheet metal ((B) polyvinyl chloride C) fiberglass (D)

A and C apply - ✔✔A 511.2



Unlisted vented gas fireplaces shall have a clearance at the sides and rear of not less than _____

inches. Is the Answer: A. 10" B. 12" C 16" D. 18". - ✔✔D. clearance of an unlisted vented gas

fireplace at the sides and the rear not less than 18". UMC Section 908.2(B)



Leaks in gas piping shall be located _____.(A) with a sniffer(B) with a presto-lite flame (C) with

a noncorrosive leak-detecting fluid (D) by increasing the air pressure during a test until the leaks

are heard as a whistle. - ✔✔C. leaks in a gas piping shall be located with a non corrosive leak

detecting fluid. UMC Section 1316.4.2



Condensate drain piping shall have a slope of not less than _____ inch per foot. A 1⁄8" B.¼"

C.½" D. 1" - ✔✔A. Slope of not less than 1/8" per foot. UMC Section 309.1



The minimum gauge or size steel wire used to support horizontal metal ducts 10 inches or less in

size is _____. A.14 AWG B.16 AWG C.18 AWG D.20 AWG - ✔✔C. 18 Minimum Gauge note:

AWG is the abbreviation for "gauge size" Table 6-7(B)



When smoke detectors are required as part of an automatic shutoff system, they shall be installed

in the _____. A. return air duct ahead of any fresh-air inlet(B) main supply air duct served by

, such equipment(C) fresh-air inlet(D) main return and the main supply duct. - ✔✔B. shall be

installed in the main supply air duct served by equipment. UMC Section 609.0(5)



The largest fuel-burning appliance allowed in a room 100'W x 20'L x 8'H without combustion air

openingsis _____ Btu.(A) 80,000 (C) 140,000(B) 100,000 (D) 320,000 - ✔✔31 D. 701.2.1



Return air ducts that serve a dwelling unit shall be permitted to be of _____ construction? A.non-

combustible B. combustible C. rated D. none of the above. - ✔✔B. Shall be permitted to be of

combustible type UMC Section 602.2 Ex (1)



Solid fuel-burning appliances _____ be connected to a venting system that serves a gas- or oil-

burningappliance.(A) shall (B) may (C) shall not(D) with special approval may - ✔✔C.

appliances shall not UMC Section 802.5.5.1



Any joint obtained by joining of metal parts with alloys that melt at temperatures higher than

840°F, but lowerthan the melting temperature of the parts to be joined, is a _____ joint.(A)

brazed(B) fused (D) soldered (C) welded - ✔✔A. Is a brazed joint UMC section 2 1 2.0



A vessel or arrangement of piping or tubing in which vaporized refrigerant is liquefied by

removal of heat is a _____.(A) compressor (C) evaporator(B) generator (D) condenser - ✔✔D. A

condenser is the piping which vaporizes the refrigerant liquefied by removal of heat, UMC

Section 2 0 5.0

Les avantages d'acheter des résumés chez Stuvia:

Qualité garantie par les avis des clients

Qualité garantie par les avis des clients

Les clients de Stuvia ont évalués plus de 700 000 résumés. C'est comme ça que vous savez que vous achetez les meilleurs documents.

L’achat facile et rapide

L’achat facile et rapide

Vous pouvez payer rapidement avec iDeal, carte de crédit ou Stuvia-crédit pour les résumés. Il n'y a pas d'adhésion nécessaire.

Focus sur l’essentiel

Focus sur l’essentiel

Vos camarades écrivent eux-mêmes les notes d’étude, c’est pourquoi les documents sont toujours fiables et à jour. Cela garantit que vous arrivez rapidement au coeur du matériel.

Foire aux questions

Qu'est-ce que j'obtiens en achetant ce document ?

Vous obtenez un PDF, disponible immédiatement après votre achat. Le document acheté est accessible à tout moment, n'importe où et indéfiniment via votre profil.

Garantie de remboursement : comment ça marche ?

Notre garantie de satisfaction garantit que vous trouverez toujours un document d'étude qui vous convient. Vous remplissez un formulaire et notre équipe du service client s'occupe du reste.

Auprès de qui est-ce que j'achète ce résumé ?

Stuvia est une place de marché. Alors, vous n'achetez donc pas ce document chez nous, mais auprès du vendeur ExcellentScores. Stuvia facilite les paiements au vendeur.

Est-ce que j'aurai un abonnement?

Non, vous n'achetez ce résumé que pour $9.99. Vous n'êtes lié à rien après votre achat.

Peut-on faire confiance à Stuvia ?

4.6 étoiles sur Google & Trustpilot (+1000 avis)

65040 résumés ont été vendus ces 30 derniers jours

Fondée en 2010, la référence pour acheter des résumés depuis déjà 15 ans

Commencez à vendre!
$9.99
  • (0)
Ajouter au panier
Ajouté