MD Masonry NOCTI Questions And Correct Answers
MD Masonry NOCTI Questions And Correct Answers The tool used to apply and spread mortar when laying brick or block is the - Answer -trowel A piece of metal used for securing line at both ends of course height is a - Answer -line pin The tool used to create a concave appearance to mortar joints - Answer -round jointer The hammer used to cut brick or block is the _____ hammer - Answer -brick The tool used for marking straight lines on footings and walls is the - Answer -chalk line The tool used for holding the line to prevent sag or wind movement is the - Answer -trig To cut reinforcing wire, the tool to choose would be - Answer -a bolt cutter Identify the tool used to force mortar into joints where holes or cracks appear in old or new brick or stonework - Answer -tuck pointer To mark various angles, the mason would choose - Answer -a bevel square Identify the power driven table saw used for cutting masonry units - Answer -masonry saw Identify the power driven hammer used for chipping and drilling holes in masonry - Answer -hammer drill The piece of equipment used to carry materials from ground level to a scaffold is - Answer -The conveyor, the hoist, the fork lift Identify the machine used for mixing mortar - Answer -mortar mixer Identify the tool used by laborers or brick tenders to move or carry brick - Answer -brick tongs A reel-type container holding chalk and the line that is used to lay out lines on floors and walls is the - Answer -chalk line A chisel used to chip mortar from joints is the - Answer -plugging chisel A chisel used to cut brick or block is the - Answer -brick set A tools used for leveling and plumbing and also used as a straight edge is the - Answer -level A power tool used to cut damaged joints is the - Answer -tuck-pointer's grinder The purpose of a mason's line is to - Answer -keep the walls in true alignment, keep the courses straight and keep the courses plumb and level The #6 on a standard spacing rule equals a _____ size bed joint - Answer -3/8" The tool used to shape, waterproof, and beautify mortar joints in masonry is the - Answer -jointer A safety rule for using the masonry saw is - Answer -wear goggles, ground the saw and stand clear of debris Soft shoes should not be worn on the job because they - Answer -offer no protection to the feet When lifting, it is best to keep the feet close together and the back in a straight position. The weight is then supported mainly by the - Answer -legs The main reason a mason should stand on a wooden board or platform when operating the masonry saw is because it - Answer -reduces the chance of being electrically shocked Footboard scaffolding should not be built higher than _____ inches - Answer -16 If nails are protruding through a scaffolding board, the proper procedure to follow is to - Answer -pull out the nails If plywood is used for the scaffolding platform in place of wooden planks, select a thickness of _____ inches - Answer -3/4" To prevent the planks from slipping off the brackets on the ends of scaffolding, they should be - Answer -cleated on the bottom To provide the best load distribution of materials on the scaffolding, materials should be stacked - Answer -over the frames What should be applied to skin burns - Answer -cold water
École, étude et sujet
- Établissement
- NOCTI
- Cours
- NOCTI
Infos sur le Document
- Publié le
- 14 mai 2024
- Nombre de pages
- 16
- Écrit en
- 2023/2024
- Type
- Examen
- Contient
- Questions et réponses
Sujets
- md masonry
- md masonry nocti
-
md masonry nocti questions
-
md masonry nocti questions and correct answers
Document également disponible en groupe