100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
NATE Heat Pump Exam 2024 Questions with 100% Correct Answers $10.39   Add to cart

Exam (elaborations)

NATE Heat Pump Exam 2024 Questions with 100% Correct Answers

 2 views  0 purchase
  • Course
  • Institution

NATE Heat Pump Exam 2024 Questions with 100% Correct Answers R-22 vapor line diameters and lengths are typically specified for a vapor pressure drop that does not exceed 6-7 psi or 6 degress F The primary purpose of using flux when soldering copper or brass parts is to prevent Oxidation ...

[Show more]

Preview 2 out of 9  pages

  • May 15, 2024
  • 9
  • 2023/2024
  • Exam (elaborations)
  • Questions & answers
avatar-seller
NATE Heat Pump Exam 2024 Questions with
100% Correct Answers
R-22 vapor line diameters and lengths are typically specified for a vapor pressure drop that does not
exceed
6-7 psi or 6 degress F


The primary purpose of using flux when soldering copper or brass parts is to prevent
Oxidation


The water that results from a defrost cycle of an air to air heat pump (runoff) must drain off and away
from the outdoor coil to prevent
Excessive ice build up


The component used to reduce sound transmission and prevent water leaks of a packaged heat pump
installed on a roof is the
Curb gasket


When under a deep vacuum, a hermetic refrigeration compressor's motor windings could be
________ if energized
Damaged


In order for an evacuation to be considered complete, a heat pump refrigerant circuit should be
evacuated to a vacuum pressure of
500 microns or below


A system is supplied from the factory with charge for a 15 foot line set. The data plate shows the
required system charge to be 5 pounds 10 ounces. The line set uses a 3/8 inch liquid line and is 25
feet long. The manufacturer's instruction sheet specifies 0.6 ounces of refrigerant to be added for
each added foot of refrigerant line length so the total refrigerant charge for the system would be
6 lbs(25-15=10 10x0.6=6oz 6oz+5lbs 10oz= 5lbs 16oz the equilvalent of 6lbs)


Drive slips are typically installed on the __________ sides of rectangular ducts
Shorter


To properly set a heat anticipator it is necessary to check the
heating control circuit amperage draw


A heat pump operating in normal ice free conditions maintains a certain temperature difference
between the outdoor coil temperature and the surrounding outdoor ambient. This temperature
difference is referred to as
Coil TD (temperature difference)


The smallest refrigerant leak that an electronic leak detector should be capable of sensing is
0.05 oz. per year

, When checking the pressures in an operating system with a manifold gauge set, refrigerant oil in a
hose will have ___ ______ on the gauge reading
No effect


At sea level, a gauge pressure of 35 psig is equal to an absolute pressure of
49.7 psia


A technician measures the return air temperature of a 100,000 Btu output furnace to be 65°F and the
supply side air temperature is 135°F. The CFM would be
1323 (TD= 135-65=70➡️100,000/TDx1.08 ➡️100,000/75.6=1323)


A residential supply diffuser that is noisy because of a loose vane is best serviced by
Replacing the diffuser


When performing preventive maintenance on a heat pump the technician should check the outdoor
fan to be certain that the fan
runs freely with no binding


What is the effect of 170 volts supplied to a 208/230 volt compressor would cause a current
increase and the motor may trip on overload


On a service call for a cooling problem with a heat pump, your inspections find a liquid line that has
condensation on it. The most likely cause would be the
liquid line is restricted


A reason for cool air complaints when a heat pump is operating in the heating cycle is
excessive supply air velocities


A dirty or clogged air filter in an operating heat pump system can cause
inadequate heating


To minimize noise problems in residential duct systems, the range (recommended to maximum) of
design air velocity in the rectangular main supply trunk is
700 to 900 fpm


The effect of adding a charge to sub cooling is
it increases it


When a capillary tube is overcharged you would get a ____ superheat and ____ sub cooling
Low,high


The effect of a low charge on the switchover operations of a reversing valve is
the reversing valves are less likely to transfer

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller LectAziim. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for $10.39. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

81531 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy study notes for 14 years now

Start selling
$10.39
  • (0)
  Add to cart