NICET fire alarm systems level 1 exam Questions and answers, rated A+[LATEST EXAM UPDATES]

NICET fire alarm systems level 1 exam Questions and answers, rated A+ if a combination audible/visible appliances are installed, the location of the installed appliance shall be determined by the requirements of - the visible appliance what is the maximum number of 12-gaugeTHHN conductors that can be installed in 1-inch EMT - 26 Do you resistors are connected in parallel. R1 = 300 Ohms, R2 = 300 Ohms. What is the equivalent resistance? - 150 Ohms I room is 200 feet long and 100 feet wide, and the 8 foot high ceiling is smooth and flat. A spot-type heat detector has been selected that is listed for a 50 foot maximum spacing between detectors. According to NFPA 72, how many detectors will be needed to protect this room? - 12 Fire warning equipment to be installed and residential occupancy's child produced audible emergency evacuation signal described in - ANSI S3.41 According to NFPA 72, the minimum number of restorable fixed-temperature spot-type heat detectors that must be tested during each annual test is - Two detectors are more on each initiating device circuit According to, how many spot type heat detectors are required for a space that is 80 foot long and 55- foot wide with a smooth 10 foot ceiling? The heat detector is listed for a maximum space between detectors of 30 feet. - 6 And what is the color code requirement for a spot type heat detector rated at 200°F - White I unless otherwise recommended by manufacture is publi