Exam (elaborations)
ASE A4 Steering And Suspension: Questions/Answers
- Course
- Institution
ASE A4 Steering And Suspension: Questions/Answers
[Show more]
Content preview
ASE A4 Steering And Suspension: Questions/Answers Which of the following is the proper way to adjust the rack yoke bearing?A. Tighten to 75 ft lbs.
B. Tighten to 5 inch lbs.
C. Tighten and then back off the original equipment manufacturer's (OEM) specifications.
D. Tighten to 0.002" end-play. Correct Ans - Tighten and then back off the originial equipment manufacturer's (OEM) specifications. Many OEMs will recommend that the technician tighten to a specification then back off a certain number of degrees.
A customer says that the steering wheel turns more turns to the left than the right. Which of the following is the LEAST LIKELY cause?
A. Incorrectly timed steering gear
B. Bent pitman arm
C. Faulty power steering pump
D. Bent tie rod Correct Ans - Faulty power steering pump. A faulty power
steering pump would not change the relationship between the steering wheel and the steering stops.
A vehicle is hard to steer in one direction only. Which of the following could be
the cause?
A. Tight joint in the steering shaft
B. Loose joint in the steering shaft
C. Faulty power steering pump
D. Fault power steering gear Correct Ans - Faulty power steering gear. A leaking seal in a power steering gear could affect steering in both directions.
The rear tires have a diagonal wear pattern. Which of the following is the most
likely cause?
A. Rear toe
B. Rear camber
C. Front camber
D. Front caster Correct Ans - Rear toe. Incorrect rear toe causes a diagonal swipe wear pattern on rear tires.
A customer says their car makes more noise on asphalt than on concrete road surfaces. Which of the following could be the cause? A. Front wheel bearing wear
B. Rear wheel bearing wear
C. Aggrresive tire tread patterns
D. Incorrect alignment angles Correct Ans - Aggressive tire tread patterns. Tires with very aggressive tread patterns are noisy. This noise will vary with different types of finish on the road surface.
There is a loud roaring noise while driving. The noise gets louder when vehicle speed increases. Which of the following could be the cause?
A. Worn power steering pump
B. Worn wheel bearing
C. Worn ball joint
D. Worn power steering gear Correct Ans - Worn wheel bearing. This is a
typical wheel bearing diagnosis.
A setback condition is found during an alignment. Which of the following could be the cause?
A. Worn spring shackle
B. Worn spring eye bushing
C. Worn tie rod end
D. Worn pitman arm Correct Ans - Worn spring eye bushing. A worn spring eye bushing could allow the rear axle to shift and setback to occur.
There is a whining noise heard only when turning. Which of the following could be the cause? A. Leaking internal seals in the steering gear
B. Worn ball joint
C. Worn power steering gear
D. Worn power steering pump Correct Ans - Worn power steering pump.
A worn power steering pump can cause noise while turning.
The front leaf springs have been replaced on a vehicle. Which of the following operations must also be performed. A. Vehicle alignment
B. Tire rotation
C. Tire balance
D. Rear spring replacement Correct Ans - Vehicle alignment. After the springs are replaced, the vehicle alignment will be changed. Therefore, the vehicle must be aligned. A vehicle has worn jounce bumpers. Which of the following could be the cause? A. Leaking shocks
B. Leaking power steering pump
C. Leaking power steering gear
D. Worn strut bearings Correct Ans - Leaking shocks. Leaking shocks can
allow the vehicle to bottom out on rough road surfaces.
A worn idler arm would affect which alignment angle?
A. Camber
B. Caster
C. Toe D. SAI Correct Ans - Toe. Toe is directly affected by the idler arm. A worn
idler arm would allow toe to change while traveling down the road.
A shifted front cradle could affect any of these EXCEPT: A. Front camber.
B. Front caster.
C. Thrust line.
D. Thrust angle. Correct Ans - Thrust line. The thrust line is the direction the rear wheels are pointing; this would not be affected by a shifted front cradle.
There is a pull on acceleration and deceleration. Technician A says spring eye bushings could be the cause. Technician B says worn strut rod bushings could be the cause. Who is right? Correct Ans - Both Technicians are correct. Spring eye bushings and worn strut rod bushings can both allow the control arm to move when the vehicle is driven.
A composite leaf spring is being installed in a vehicle. Which of the following is
correct?
A. The spring can be installed using a pry bar.
B. The spring can be compressed with vise grips.
C. The spring should be painted after installation.
D. The spring should not be scratched during installation. Correct Ans - The spring should not be scratched during installation. The spring needs to be handled with care. If the spring is dented or scratched, it will be weakened and break. Which of the following alignment specification would most likely need a steering damper. A. 6 degrees caster.
B. 2 degrees camber
C. 2 degrees caster
D. 6 degres camber Correct Ans - 6 degrees caster. Vehicles with high caster settings are most likely to use a steering damper to help control front-
wheel shimmy.
A customer complains of a popping noise while turning the steering wheel. Which of the following is the most likely cause? A. Rear shock mounts
B. Rear toe adjusters
C. Front shock mounts
D. Front tie rods Correct Ans - Front tie rods. Worn front tie roads can make a popping noise when the steering wheel is rocked back and forth.
A power steering pump hose is leaking on a vehicle. Which of the following is the most likely cause? A. Separated motor mounts
B. Loose drive belt
C. Air in the fluid
D. Broken pump mounts Correct Ans - Separated motor mounts. It is possible that separated motor mounts could cause the hoses to be stretched and leak.
Which angle has the greatest affect on steering wheel return? A. Camber
B. SAI
C. Toe
D. Caster Correct Ans - Caster. Caster greatly affects steering wheel return.
There is a vibration which can be felt in the steering wheel at speeds above 30 mph. Which of the following could be the cause?
A. Front wheels out of balance
B. Rear wheels out of balance
C. Caster
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller LeCrae. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $21.99. You're not tied to anything after your purchase.
Can Stuvia be trusted?
4.6 stars on Google & Trustpilot (+1000 reviews)
73091 documents were sold in the last 30 days
Founded in 2010, the go-to place to buy study notes for 14 years now