Orientation to the Electrical Trade Module Exam with A Grade Solutions.docx

Orientation to the Electrical Trade Module Exam with A Grade S Conduit systems in volatile environments must be . - Answer-sealed OSHA standards provided specifically for the construction industry are covered in . - Answer-29 CFR 1926 Electrical licensing requirements are set by . - Answer-states or municipalities Before awarding a journeyman certificate, a typical electrical apprenticeship program requires 8,000 total hours of . - Answer-on-the-job learning An electrician who must know how to disassemble and reassemble magnetic motor starters is a(n) . - Answer-electrical maintenance electrician Electrical contractors typically employ . - Answer-commercial electricians Why must an arcing device be contained within a special enclosure? - Answer-To prevent the ignition of hazardous vapors Installing nail-on device boxes, panelboards, and lighting fixtures in new houses are tasks performed by . - Answer-residential electricians To install a raceway system without wasting material, an electrician must be skilled in . - Answer-conduit bending Electricians who are responsible for their own taxes and providing their own insurance are considered . - Answer-individual contractors Electricians that work with three-phase power, motors, and motor control systems most likely work in . - Answer-industrial facilities A trainee must demonstrate knowledge of the hands-on tasks learned in each module. This is referred to as . - Answer-a competency-based program Apprentices typically receive a pay increase after each . - Answer-1,000 hours of related work Which of the following describes the standard in NFPA 70E®? - Answer-Safe work practices must be applied when working on or near exposed energized parts According to OSHA standards, your employer must . - Answer-show you how to do each job safely