100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
Previously searched by you
Previously searched by you
logo
API 1169. study test questions test $10.99
Add to cart
Quickly navigate to
Preview
  2.  
  3. API 1169
  4.  
  5. API 1169

Exam (elaborations)

API 1169. study test questions test
 0 purchase
  • Course
  • API 1169
  • Institution
  • API 1169

API 1169. study test questions test RM#1 According to FERC, environmental Inspectors shall have _____________ status in regards to all other craft inspectors. Equal According to Title 49 CFR 195, any new pipe with a diameter greater than ___________ inches must be marked with the specificati...

[Show more]

Preview 2 out of 13  pages

Document information

  • June 13, 2024
  • 13
  • 2023/2024
  • Exam (elaborations)
  • Questions & answers

Subjects

  • api 1169 study test questions test rm1 according

Written for

  • API 1169
All documents for this subject (166)

Seller

avatar-seller
ACADEMICAIDSTORE

Reviews received

Content preview

API 1169. study test questions test RM#1
According to FERC, environmental Inspectors shall have _____________ status in regards to all other
craft inspectors.
Equal


According to Title 49 CFR 195, any new pipe with a diameter greater than ___________ inches must
be marked with the specification, the SMYS/Grade, and pipe size.
4.5


This legislation covers hazardous substance, site contamination, and cleanup
Comprehensive environmental recovery, compensation, and liability act.


A blueprint showing the exact route of a pipeline and virtually all of the knowledge that exist for that
pipeline when constructed is called a ______________?
Alignment sheets


In area is considered oxygen deficient if the oxygen level is below ___________ %
19.5


During a pressure test, if a leak develops on a connection, yomust depressurize to a safe level and
then
re-tighten the connections


Which listed non-destructive testing method is specified in API 1104?
RT examination


Prior to a hydrotest, ensure that the _______ has approved the de-watering location.
Environmental Inspector


As an inspector, you should ensure that there is always a (n) on a site with an open excavation.
designated competent person


Calculate the top width of a bell hole excavation using the following information: Depth of ditch: 8
feet Bottom Width: feet Soil type: C
30 : formula soil type C : 3 x depth + bottom width = top width


Demonstrated ability to apply knowledge and skills.
competence


According to the EPA, which phase covers containment, countermeasures, cleanup, and disposal for
response for oil removal after a spill.
Phase III

, Which refarence in 40 CFR Part 300 claifies procedures for planning and implementing off-site
response actions for hazardous substances?
300.440


The color code for marking oil & gas buried utilities during sweep is _____________?
yellow


According to OSHA, excavations that are less than 5' in depth & the examination of the ground by a
competent person provides no indication of a potential cave-in, is not required to have any type of
protection system.
True


MOC stands for ____________?
management of change


Replica tape is used during __________ measurements?
surface profile


Where can the exact code for strength test requirements be found for carbon steel (natural gas)
pipelines to operate at a hoop stress of 30% or more of SMYS?
192.505


Title 49, CFR 195: The total number of girth welds and the number nondestructively tested, including
the number rejected and the disposition of each rejected weld records must be maintained for at
least
5 years


According to Title 49, CFR 192, Subpart N: Records of prior qualification and records of individuals no
longer performing covered tasks shall be retained for a period of ______________ years.
5


During weld qualification, the fillet weld specimens can be broken inside the weld by any convenient
method.
true


The excavation tolerance zone is __________from center-line of proposed excavation. The
excavation.
24 inchs


Typically, the test pressure ratio is 1.25 and the duration is 4 hours or longer during __________?
strength test


In recards to hazardous liquids pipelines, what is the API RP that must be followed in order to use pipe
transported via railroad if it has an OD to WT ratio of 75 to 1 and that will be operated at a hoop
stress of 25% of SMYS?
API RP SL1

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller ACADEMICAIDSTORE. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for $10.99. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

69052 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy study notes for 15 years now

Start selling
$10.99
  • (0)
Add to cart
Added