ISTQB Foundation Level Study Guide Actual Exam Questions 100% Correct Answers Verified 2024 Version
1 view 0 purchase
Course
Academic Avengers Verified Papers
Institution
Academic Avengers Verified Papers
ISTQB Foundation Level Study Guide |
Actual Exam Questions | 100% Correct
Answers | Verified 2024 Version
What is the test basis?
a. The point during software development when testing should start
b. The body of knowledge used for test analysis and design
c. The source to determine the actual...
ISTQB Foundation Level Study Guide |
Actual Exam Questions | 100% Correct
Answers | Verified 2024 Version
What is the test basis?
a. The point during software development when testing should start
b. The body of knowledge used for test analysis and design
c. The source to determine the actual results from a set of tests
d. The method used to systematically devise test conditions - ✔✔B
(B is correct. Per the glossary, the test basis is "a source to determine expected results to compare with
the actual result of the system under test". A is not correct because this is usually defined as the
moment of involvement for testing. C is not correct because this is the test oracle. D is not correct
because the test basis is not a method)
When the tester verifies the test basis while designing tests early in the lifecycle, which common test
objective is being achieved?
a. Gaining confidence
b. Finding defects
c. Preventing defects
d. Providing information for decision making - ✔✔C
(C is correct per the syllabus. The other three are achieved primarily by doing dynamic testing. This is a
bit tricky because you are very likely to find defects while doing this analysis and this may lead to either
gaining or destroying confidence and needing to supply information to the decision makers. However,
the wording of the question matches the wording in the syllabus that defines preventing defects.)
When following the fundamental test process, when should the test control activity take place?
a. During the planning activities
b. During the implementation and execution activities
c. During the monitoring activities
d. During all the activities - ✔✔D
,(D is correct. Control occurs throughout the
project to ensure that it is staying on track based
on the plan and to take any corrective steps that
may be necessary. The monitoring information is
used to determine if control actions are needed.)
Which of the following is a correct statement?
a. A developer makes a mistake which causes a defect that may be seen as a failure during dynamic
testing
b. A developer makes an error which results in a failure that may be seen as a fault when the software is
executed
c. A developer has introduced a failure which results in a defect that may be seen as a mistake during
dynamic testing
d. A developer makes a mistake which causes a bug that may be seen as a defect when the software is
executed - ✔✔A
(A is correct. The developer makes a mistake/error which causes a defect/fault/bug which may cause a
failure when the code is dynamically tested or executed. B is incorrect because fault and failure are
reversed. C is incorrect because failure and mistake are reversed. D is incorrect because it's a failure
that's seen during execution, not the defect itself. The failure is a symptom of the defect.)
Which of the following is an example of debugging?
a. A tester finds a defect and reports it
b. A tester retests a fix from the developer and finds a regression
c. A developer finds and fixes a defect
d. A developer performs unit testing - ✔✔C
(C is correct. Debugging is what the developer
does to identify the cause of the defect, analyze
it and fix it. D may involve debugging, if the
developer finds a defect, but the act of unit
testing is not the same as debugging.)
,Which of the following is a true statement about exhaustive testing?
a. It is a form of stress testing
b. It is not feasible except in the case of trivial software
c. It is commonly done with test automation
d. It is normally the responsibility of the developer during unit testing - ✔✔B
(B is correct. Exhaustive testing, all combinations
of inputs and preconditions, is not feasible unless
the software is trivially simple.Otherwise it would
take too long and might not even be possible.)
A new retail product was released to production by your company. Shortly after the release it was
apparent that there were numerous problems with the point of sale application. This resulted in a
number of customer complaints and negative postings on social media encouraging people to take their
business to your competitor. You have investigated the problems and have discovered that the
production point of sale equipment is a later model than the model used in testing. The software
functions correctly on the old version, but fails on the later model.
Given this scenario, what is the root cause and what is the effect?
a. The root cause is the old equipment and the effect is the new equipment
b. The root cause is the customer complaints and the effect is the social media postings
c. The root cause is conducting the testing on the wrong version of the equipment and the effect
is the customer complaints and postings
d. T - ✔✔C
(C is correct. The root cause is that the testing,
and maybe the development, were conducted on
the wrong version of the POS equipment. The
effect of the problem is the customer complaints
and the social media postings.)
If you need to provide a report showing test case execution coverage of the requirements, what do you
, need to track?
a. Traceability between the test cases and the requirements
b. Coverage of the risk items by test case
c. Traceability between the requirements and the risk items
d. Coverage of the requirements by the test cases that have been designed - ✔✔A
(A is correct. In order to show the test execution
coverage of the requirements you will need
traceability between the requirements and the
test cases. As the test cases are executed this
traceability can be used to record tests executed
against the requirements. B is not correct
because it's looking for requirements coverage,
not risk coverage. C is not correct because it's
looking for test execution, not risk items. D is not
correct because it's looking for test cases that
have been executed, not just designed.)
Which of the following is most correct regarding the test level at which functional tests may be
executed?
a. Unit and integration
b. Integration and system
c. System and acceptance
d. All levels - ✔✔D
(D is correct. Functional testing should be
conducted at all levels)
Which of the following is a true statement regarding the V-model lifecycle?
a. Testing involvement starts when the code is complete
b. The test process is integrated with the development process
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller hov. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $8.99. You're not tied to anything after your purchase.
