Journeyman Electrician #2 Already Graded A+
1. Motor control circuits should be set up to disconnect from all power sources when _____ occurs. - a) the disconnecting means is in the open position. (Correct Answer: a) the disconnecting means is
in the open position) - b) the disconnecting means...
1. Motor control circuits should be set up to disconnect from all power sources when _____ occurs.
- a) the disconnecting means is in the open position. ✅ (Correct Answer: a) the disconnecting means is
in the open position)
- b) the disconnecting means is not within sight of the controller
- c) the disconnecting means is integral with the controller
- d) installed in a motor control center
- Reference: 430.75(A)
2. What is permissible for closing an unused circuit breaker slot in panelboards?
- a) Installation of a closure plate or other device that fits securely and closes the opening.
- b) Installation of a spare or unused circuit breaker that fills the opening and is listed for the
panelboard.
- c) Installation of a closure plate listed for the purpose by the manufacturer.
- d) All of these are permitted. ✅ (Correct Answer: d) All of these are permitted)
- Reference: 408.7
3. For commercial buildings, general-purpose receptacle loads must be calculated at a minimum of
_____ VA per single or duplex receptacle before applying demand factors.
- a) 100
- b) 120
- c) 150
- d) 180 ✅ (Correct Answer: d) 180)
- Reference: 220.14(I)
4. Which listed conductor insulation has a higher temperature rating when used in dry locations
compared to wet locations?
- a) THW
, - b) RHW
- c) THWN
- d) THHW ✅ (Correct Answer: d) THHW)
- Reference: Tbl. 310.13(A); Tbl. 310.16
5. Which of the following scenarios concerning grounding would NOT comply with NEC standards?
- I. Steel reinforcing bars intended for concrete foundations but not connected to the grounding
system.
- II. Concrete foundations with steel reinforcing bars that were unavailable for grounding because the
concrete was poured before the electrical contractor arrived.
- a) I only ✅ (Correct Answer: a) I only)
- b) II only
- c) both I and II
- d) neither I nor II
- Reference: 250.50, Ex.
6. In a healthcare facility, low-voltage electrical equipment, likely to be energized and frequently in
contact with patients, must operate on a voltage of _____ volts or less unless it is approved as
intrinsically safe, double-insulated, or moisture-resistant.
- a) 10 ✅ (Correct Answer: a) 10)
- b) 24
- c) 100
- d) 120
- Reference: 517.64(A)(1), (2), and (3)
7. When ambient temperature is not a concern, what is the MAXIMUM allowable ampacity of a size 8
AWG single copper conductor with FEPB insulation installed in free air?
- a) 80 amperes ✅ (Correct Answer: a) 80 amperes)
- b) 55 amperes
- c) 45 amperes
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller bestscores1. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $10.92. You're not tied to anything after your purchase.
