100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
OSHA 3115 - FALL PROTECTION || with 100% Accurate Solutions. $10.65   Add to cart

Exam (elaborations)

OSHA 3115 - FALL PROTECTION || with 100% Accurate Solutions.

 7 views  0 purchase
  • Course
  • OSHA 3115 - FALL PROTECTION
  • Institution
  • OSHA 3115 - FALL PROTECTION

Fall protection retraining is required when there is indication that_______. (1926.503(b)) correct answers -an employee has not retained requisite knowledge, understanding and skills needed to use PFAS equipment -There are changes in the types of fall protection systems used -There are changes in...

[Show more]

Preview 2 out of 5  pages

  • August 9, 2024
  • 5
  • 2024/2025
  • Exam (elaborations)
  • Questions & answers
  • OSHA 3115 - FALL PROTECTION
  • OSHA 3115 - FALL PROTECTION
avatar-seller
FullyFocus
OSHA 3115 - FALL PROTECTION || with 100% Accurate
Solutions.
Fall protection retraining is required when there is indication that_______. (1926.503(b)) correct
answers -an employee has not retained requisite knowledge, understanding and skills needed to
use PFAS equipment
-There are changes in the types of fall protection systems used
-There are changes in the workplace

The maximum allowed free fall distance is ________while using a personal fall arrest system:
(1926.502(d)(16)(iii)) correct answers 6 feet

Is it the "fall" or the "Sudden stop" that causes the injuries to the body? correct answers True

Under OSHA 1926.503 (of Subpart M), the employer is required to provide _______ for each
employee who might be exposed to fall hazards. correct answers Certified and documented
training

The fall protection plan shall identify each location where conventional fall protection systems
cannot be used; these locations shall be classified as___________. correct answers Controlled
Access Zones

The option of a fall protection plan is available only to employees engaged in _________ who
can demonstrate that it is infeasible or it creates a greater hazard to use conventional fall
protection systems, correct answers -Loading edge work
-Residential construction work
-Precast concrete erection work

In a control access zone, the control line shall extend along the entire length of the unprotected or
leading edge and shall be approximately ________ to the unprotected or leading edge. correct
answers parallel

A safety monitor is required by OSHA when correct answers -Roofing work on flat roofs when
not using conventional fall protection systems
If infeasible or a greater hazard to provide conventional fall protection system, and using a fall
protection Plan when doing leading edge work, precast concrete erection or residential work

The safety monitor shall remain close enough to employees to communicate _________.
(1926.502(h)(1)(iv)) correct answers Orally

Warning lines shall be _________high. (1926.502(f)(2)(i)) correct answers 34" to 39"

Warning lines during roof work shall be erected around all sides of the roof work area where fall
potential is greater than a 6 foot. When mechanical equipment is not being used, the warning line
shall be erected no less than _____ feet from the roof edge. correct answers 6 feet

, Positioning devices shall be rigged such that an employee cannot free fall more than __ feet.
correct answers 2 feet

As of January 1, 1998 ______ are not acceptable as part of a personal fall arrest system.
(1926.502(d)) correct answers body belts and non-locking snaphooks

Lanyards and vertical lifelines shall have minimum breakage strength of ________ pounds.
(1926.502(d)(9)) correct answers 5000

The maximum size of each safety net mesh opening shall not exceed _____square inches. correct
answers 6" x 6" or 36 (p131)

If there are workers on stilts that are higher than the guardrail, OSHA states what: (1926.502(b)
(1)Note) correct answers The top rail must be increased in height to equal height of the stilts

Guardrail systems shall be capable of withstanding, without failure, a force of at least ____
pounds applied with two inches of the top edge, in any outward or downward direction, at any
point along the top edge. (1926.502(b)(3)) correct answers 200

An employee on a walking/working surface shall be protected from falling through holes
(including actual skylights) more than 6 feet above lower levels by personal fall arrest systems,
_______, or guardrail systems erected around such holes, openings or skylights. (1926.502(i)(4))
p148 correct answers covers

The fall protection requirements of Subpart M - do not apply to the following situations (Choose
all that apply) correct answers -erection or dismantling of scaffolding, scaffold use
-steel erection
-stairways and ladders
-utility pole work

Carpenters are installing 4'x8' sheets of plywood onto roof trusses in order to make a roof deck
which will have a pitch of 8/12. Their ground to eave fall height is 20 feet and their only fall
protection is a single 2" x 6" slide guard. There is a fall hazard here; what OSHA standard
applies. correct answers 1926.501(b)(13)-Residential construction

A Scaffold erector is erecting a 30 foot high scaffold, but is not using a personal fall arrest
system. What OSHA standard applies to a scaffold erector/dismantler NOT using fall protection?
correct answers 1926.451(g) (2)- Scaffold competent person determination

How high (in feet) according to OSHA are you allowed to free climb on reinforcing steel (rebar)
cages Construction correct answers 25

No employee shall be permitted to place or tie reinforcing steel more than _____ feet above any
adjacent work surface unless other fall protection is provided (1926.501(b)(5)) correct answers 6

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller FullyFocus. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for $10.65. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

79373 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy study notes for 14 years now

Start selling
$10.65
  • (0)
  Add to cart