100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
Residential wireman test part 1 Questions and answers | Latest 2024/25 RATED A+ $10.49   Add to cart

Exam (elaborations)

Residential wireman test part 1 Questions and answers | Latest 2024/25 RATED A+

 5 views  0 purchase
  • Course
  • Residential wireman
  • Institution
  • Residential Wireman

Residential wireman test part 1 Questions and answers | Latest 2024/25 RATED A+

Preview 2 out of 10  pages

  • August 15, 2024
  • 10
  • 2024/2025
  • Exam (elaborations)
  • Questions & answers
  • Residential wireman
  • Residential wireman
avatar-seller
STUVATE
Residential wireman test part 1
Questions and answers | Latest 2024/25
RATED A+
The National Electrical Code not intended as ________. - design specification or as an
instrucion manual

The provisions of the national electrical code are considered necessary for ________.
- safety

What is not covered within the scope of the national electrical code? - installation in
underground mines

Which chapter of the national electrical code covers communications systems? -
chapter 8

The informational annexes of the national electrical code are for ______. -
informational purposes only

If the current edition of the national electrical code requires the use of a new product
but that product is not yet available then the _____ may permit the use of a product
from the most recent previous edition. - authority having jurisdiction

A rule that identifies actions that are allowed but not required is ______. - Permissive

It is not necessary to inspect a piece of equipment that has not been altered or
damaged and has been listed by a qualified electrical testing laboratory is the be
installed in a structure - True

Distribution centers located in readily accessible locations provide _______. -
Convenience and safety of operation

Limits on the number of circuits in a single enclosure minimize the effects from a
_______. - Ground fault or short circuit

Where units of measurement are used in the national electrical code they are given in
_______ units. - Inch-pound and/or SI

When a hard conversion is made the ________ may change. - dimensions

Accessible as applied to equipment means admitting close approach and not guarded
by _____. - elevation, locked doors, or other affective means.

, The ampacity is the maximum current, in ampheres, that a conductor can carry
continuously under the conditions of use without exceeding its ______ rating. -
Temperature

An arc-fault circuit interrupter, or AFCI is a device which provides protection from the
effects of arc faults by _______. - recognizing characteristics unique to arcing and
functioning to de-energize the circuit when an arc fault is detected

Askarel is a ______ term for a group of non-flammable synthetic chlorinated
hydrocarbons used as electrical insulating media - generic

Bonding means connected to establish electrical ______. - conductivity and continuity

A bonding jumper is a connection between a grounded circuit conductor and ______,
at a separately derived system. - a supply-side bonding jumper and an equipment
grounding conductor

A _____ is the circuit conductors between the final overcurrent device protecting the
circuit and the outlets. - Branch circuit

Finely divided solid material that is a maximum of _______ microns and presents a fire
or explosion hazard dispersed and ignited in air is combustible dust. - 500

A pressure connector is a device that establishes a connection between ________ by
means of mechanical pressure and without the use of a solder. - -two or more
conductors
-one or more conductors and a terminal

A composite optical fiber cable contains - -optical fibers
-current carrying electrical conductors

A continuous load is a load where the maximum current is expected to continue for
_______ hours or more. - 3

A ________ is a device by which the conductors of a circuit can be disconnected from
their source of supply. - Disconnecting means

Intermittent duty is described as the operation for alternate intervals of _______. - -
load and no load
-load and rest
-load, no load and rest

Any circuit conductor between the service equipment, the source of a separately
derived system, or other power supply source and the final branch-circuit overcurrent
device is a _______. - Feeder

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller STUVATE. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for $10.49. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

81113 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy study notes for 14 years now

Start selling
$10.49
  • (0)
  Add to cart