NATE Air Conditioning and Heat Pump Questions With Correct Answers(Guaranteed Success)
7 keer bekeken 0 keer verkocht
Vak
NATE
Instelling
NATE
NATE Air Conditioning and Heat Pump Questions With Correct Answers(Guaranteed Success)
Which of the following factors affects a customers level of comfort? - correct answer...All of the above
A cooling load calculation estimates the sensible heat gain of the structure. The cooling-only system...
NATE Air Conditioning and Heat Pump
Questions With Correct
Answers(Guaranteed Success)
Which of the following factors affects a customers level of comfort? - correct
answer...✔✔All of the above
A cooling load calculation estimates the sensible heat gain of the structure. The cooling-
only system should be within _____% of this calculated value. - correct answer...✔✔
+15%
The maximum sensible cooling capacity of a heat pump should be within ______% of
the calculated sensible heat gain of a structure with a large heating load. - correct
answer...✔✔+25%
The combined output of a heatpump and its auxiliary heat should not exceed the
calculated heat loss of a home by more than ____%. - correct answer...✔✔15%
What amount of auxiliary electronic heat is needed when the output of a heat pump on a
design day equals 18,800 Btuh and the heat loss of a home is 29,700 Btuh? - correct
answer...✔✔3.2 kWh
The three processes that transfer heat energy are conduction, convection, and
_________. - correct answer...✔✔Radiation
Heat transfer that occurs when substances of different temperatures are in contact with
each other is called _______. - correct answer...✔✔conduction
What effect does raising the pressure in a sealed system have on refrigerant? - correct
answer...✔✔The boiling point increases
What is the primary danger to people near an accidental refrigerant release or spill? -
correct answer...✔✔suffocation caused by the heavier refrigerant displacing oxygen in
the air
The maximum temperature at which refrigerant may be stored is ______ F when the
container is no more than ____% full of liquid by volume.; - correct answer...✔✔125 F,
80%
Boiling of the refrigerant occurs in which system component? - correct answer...✔✔
Evaporator
AGRADESOLUTIONS
,Why is superheat necessary in a system that utilizes hermetic compressors - correct
answer...✔✔It ensures that dry vapor reaches the compressor so that mechanical
damage does not occur
When the heat load on an evaporator increases, what is the effect on the system? -
correct answer...✔✔Suction pressure and discharge pressure both increase
What type of energy is transferred when work is done in the condenser? - correct
answer...✔✔Both latent and sensible heat energy
What is the primary function performed by a thermal expansion valve? - correct
answer...✔✔It maintains the correct superheat in the suction vapor leaving the
evaporator
Which component pumps refrigerant through the system and raises the vapor
temperature? - correct answer...✔✔compressor
How are hermetic compressor motors cooled? - correct answer...✔✔With suction vapor
drawn from the evaporator
Heat pump compressors sometimes run hotter than compressors used in cooling-only
units because heat pump compressors _____. - correct answer...✔✔exhibit low
refrigerant density at low suction pressures during the heating cycle
When is crankcase heat most needed? - correct answer...✔✔When the compressor is
off
Work done on the refrigerant in the condenser is transferred as ____. - correct answer...
✔✔Both sensible and latent heat
Why are more circuits needed in the outdoor coils used in heat pumps than in the
condenser coils used in cooling-only units? - correct answer...✔✔To keep the pressure
drop across the outdoor coil low
What is they typical water flow rate per ton of cooling for water-source heat pumps
operating in closed loop systems? - correct answer...✔✔3.0 gpm per ton
What tool should be used to shorten a capillary tube? - correct answer...✔✔A triangular
or knife-edge file
Which pressure in a TEV is opening pressure? - correct answer...✔✔bulb pressure
What effect does a low refrigerant charge have on reversing valve operations? - correct
answer...✔✔It increases the chance that the reversing valve will not be able to transfer
properly
AGRADESOLUTIONS
, When adding a heat pump to an existing fossil-fuel furnace, an installer must do all of
the following except ______. - correct answer...✔✔Make sure that the new number of
fins per inch of the new coils equals that of the replaced coils
What is the purpose of a receiver? - correct answer...✔✔It store liquid refrigerant
What is the typical storage life of modern refrigerants? - correct answer...✔✔Modern
refrigerants have an indefinite storage life
Which of the following should be used to leak-test refrigerant tubing? - correct answer...
✔✔Dry Nitrogen
Of the motors commonly used in HVACR systems, which type has the lowest starting
torque? - correct answer...✔✔Shaded-pole motor
What is the typical phase angle for a split-phase motor? - correct answer...✔✔30
What determines the staging of a two-speed compressor in a heat pump application? -
correct answer...✔✔Deviation from setpoint of the thermostat
The NEC approves a _____ dual-element time-delay fuse as overcurrent protection for
a 20 A motor. - correct answer...✔✔60-A
Voltage supplied to a motor may vary from the rated voltage by _____%. - correct
answer...✔✔+10%,-10%
What is one of the most Important reasons for using electronic controls in HVACR
systems? - correct answer...✔✔they make decisions based on many inputs
Hard-start kits are often needed on ______. - correct answer...✔✔reciprocating
compressors used with TEVs
A 24-V transformer with a 40-VA rating can operate safely with a current of _____. -
correct answer...✔✔1.67 A
Some electromechanical thermostats must be connected to both sides of the
transformer in order to power the _______. - correct answer...✔✔display lights on the
subbase
A cooling anticipator in the control circuits is connected in _____ with the _____ switch
of the thermostat. - correct answer...✔✔parallel, cooling
According to Ohm's Law, what will happen if the voltage to a heater element is
increased by 10%? - correct answer...✔✔The current draw will increase by 10%
AGRADESOLUTIONS
Voordelen van het kopen van samenvattingen bij Stuvia op een rij:
Verzekerd van kwaliteit door reviews
Stuvia-klanten hebben meer dan 700.000 samenvattingen beoordeeld. Zo weet je zeker dat je de beste documenten koopt!
Snel en makkelijk kopen
Je betaalt supersnel en eenmalig met iDeal, creditcard of Stuvia-tegoed voor de samenvatting. Zonder lidmaatschap.
Focus op de essentie
Samenvattingen worden geschreven voor en door anderen. Daarom zijn de samenvattingen altijd betrouwbaar en actueel. Zo kom je snel tot de kern!
Veelgestelde vragen
Wat krijg ik als ik dit document koop?
Je krijgt een PDF, die direct beschikbaar is na je aankoop. Het gekochte document is altijd, overal en oneindig toegankelijk via je profiel.
Tevredenheidsgarantie: hoe werkt dat?
Onze tevredenheidsgarantie zorgt ervoor dat je altijd een studiedocument vindt dat goed bij je past. Je vult een formulier in en onze klantenservice regelt de rest.
Van wie koop ik deze samenvatting?
Stuvia is een marktplaats, je koop dit document dus niet van ons, maar van verkoper agradesolutions. Stuvia faciliteert de betaling aan de verkoper.
Zit ik meteen vast aan een abonnement?
Nee, je koopt alleen deze samenvatting voor $12.49. Je zit daarna nergens aan vast.
