ICBC Class 4 Questions and Answers 2024

ICBC Class 4 Questions and Answers 2024 "Public transportation" refers to: The transportation of groups of people who are not your associates or members of your family. A "bus" refers to: A motor vehicle with a seating capacity of more than 10 persons, including the driver, and which is operated for hire or for public transportation. Previous Play Next Rewind 10 seconds Move forward 10 seconds Unmute 0:12 / 0:15 Full screen Brainpower Read More A "taxi" refers to: A motor vehicle with a seating capacity of not more than 10 persons, and which is available with its driver for hire. A red triangle Slow Moving Vehicle sign should be placed on any vehicle that travels at less than: 40 km/h A vehicle that is twice the weight of a car and is traveling at twice the speed of that car requires how much braking power to stop in the same distance: 8 time's stopping power After working 120 hours in a 14-day cycle, drivers must take ____________ hours of off-duty time before working 70 hours of on-duty time. 24 hours An engine brake retarder is: a. and b. are correct. (you got it right) (More efficient at a higher engine r.p.m. and in a lower transmission gear. + Often restricted in residential areas. Any defect found on a school bus must be: Fixed before the vehicle is operated as a school bus again Any defect or deficiency that you find on your passenger vehicle must be: Reported to the carrier you work for in writing, either immediately or at the end of that day. Horsepower is: Used to develop speed. If a crash occurs while you are backing up in a large vehicle: It will almost always be considered the driver's fault Lugging occurs when: The engine is operated below peak torque for any length of time. Peak Torque is The level of torque at which you should be operating your vehicle. Stopping on icy roads requires: Light pressure on the brakes Maximum speed in an alley, unless otherwise posted is: 20 km/h To avoid fires, you should Never start a vehicle with a fuel leak. Maintain proper tire pressure. Make sure your vehicle's brakes are fully released while the vehicle is moving. All of the above. (correct answer) To dry out your brakes during extremely wet conditions you should: Apply a slight pressure to the brakes for a short distance To prevent your vehicle from jerking back after it is fully stopped, you should: Just before your vehicle comes to a full stop, reduce the pressure you are putting on the brake pedal. What are the consequences if you exceed your maximum on-duty hours and an enforcement officer stops you? You can be ordered out of service. When driving in snowy or icy conditions, you should: Test the steering and brakes for control when you start out. Avoid quick movements with the steering wheel. Maintain adequate ventilation in your cab, and make sure your exhaust system has no leaks. All of the above. (correct answer) When driving in the United States, you may drive no more than ____________ hours during your on-duty time. 11 hours When driving in the Yukon or Northwest Territories, you may drive no more than ___________ hours during your on-duty time. 15 Hours When driving through large amounts of water on the roadway you should: Apply a slight constant pressure on the brakes When parking a single unit vehicle on an upgrade and there is no curb, you should: Turn the wheels towards the edge of the roadway. When parking a single unit vehicle on an upgrade and there is no curb, you should Turn the wheels towards the edge of the roadway When refueling a school bus, you must: Make sure all passengers are off the bus When turning right in a vehicle with a lot of off track, you may have to: Cross the center line of the street you are entering. Move partially into the left lane of the street you are turning from. a. and c. are correct. Which forces are at work as you drive around a curve: Inertia and traction. Which method should you use to shift gears in a large vehicle? It depends on the vehicle. Who is responsible for making sure the emergency equipment is in working order: The carrier. You are operating a vehicle whose peak engine torque is at 1,500 r.p.m. and whose peak horsepower is at 2,000 r.p.m. When employing the standard r.p.m. split to shift gears, you should: Accelerate to 2,000 r.p.m., double-clutch, allow the engine speed to decrease to 1,500 r.p.m., and upshift. You must have at least 8 consecutive hours of off-duty time before driving after you Complete 13 hours of drive time Complete 14 hours of on-duty time both A and B are correct