1 | P a g e | © copyright 2024/2025 | Grade A+
NOCTI ENGINEERING PT2 Questions and
Correct Answers | Latest Update
What is the third color band on a resistor represents?
✓ ~~>The first and second band represent the numerical value of the
resistor, and the color of the third band specify the power-of-ten
multiplier. The fourth represents the tolerance. The color bands are
always read from left to right starting with the side that has a band
closer to the edge.
Identifying leader in the assembly process in order to routinely compare one's
processes and outputs to the leader is called
✓ ~~>Performance matching
When energized a solenoid actuates upon which of the following objects:
✓ ~~>Steel
Which statement best describes precision alignment?
✓ ~~>It corrects any defects in the shaft
The most important factor for an engineer in selecting a project solution
should be
Master01 | September, 2024/2025 | Latest update
, 2 | P a g e | © copyright 2024/2025 | Grade A+
✓ ~~>Safety
Healthier staff, increased attendance and productivity, increased morale,
and reduced litigation risks are some of the advantages of adhering to what
regulations?
✓ ~~>OSHA
An international body of technical standards for various industries, designed
to promote international trade, engineering conformance, and most recently
environmental awareness is known of
✓ ~~>International organizations for standardization
When determining the degree of acceptable risk in a project, an engineer
should always consider
✓ ~~>A cost/ risk / benefit analysis
Training and _____ may be given to comply with OSHA in the workplace
✓ ~~>Teamwork
A good method of maintain a safe work area is to maintain a clean work
bench, attend safety meetings and
Master01 | September, 2024/2025 | Latest update
NOCTI ENGINEERING PT2 Questions and
Correct Answers | Latest Update
What is the third color band on a resistor represents?
✓ ~~>The first and second band represent the numerical value of the
resistor, and the color of the third band specify the power-of-ten
multiplier. The fourth represents the tolerance. The color bands are
always read from left to right starting with the side that has a band
closer to the edge.
Identifying leader in the assembly process in order to routinely compare one's
processes and outputs to the leader is called
✓ ~~>Performance matching
When energized a solenoid actuates upon which of the following objects:
✓ ~~>Steel
Which statement best describes precision alignment?
✓ ~~>It corrects any defects in the shaft
The most important factor for an engineer in selecting a project solution
should be
Master01 | September, 2024/2025 | Latest update
, 2 | P a g e | © copyright 2024/2025 | Grade A+
✓ ~~>Safety
Healthier staff, increased attendance and productivity, increased morale,
and reduced litigation risks are some of the advantages of adhering to what
regulations?
✓ ~~>OSHA
An international body of technical standards for various industries, designed
to promote international trade, engineering conformance, and most recently
environmental awareness is known of
✓ ~~>International organizations for standardization
When determining the degree of acceptable risk in a project, an engineer
should always consider
✓ ~~>A cost/ risk / benefit analysis
Training and _____ may be given to comply with OSHA in the workplace
✓ ~~>Teamwork
A good method of maintain a safe work area is to maintain a clean work
bench, attend safety meetings and
Master01 | September, 2024/2025 | Latest update
