Exam (elaborations)
UA RIGGING
- Course
- Institution
- Book
Exam study book Safe Rigging Principles and Practices of Shankar Saran - ISBN: 9781527559660 (UA RIGGING)
[Show more]
Connected book
Book Title:
Author(s):
- Edition:
- ISBN:
- Edition:
More summaries for
-
UA RIGGING
Seller
Follow
maxmaxwellmm254
Content preview
UA RIGGING FINAL EXAM NEWEST ACTUAL EXAMCOMPLETE 150 QUESTIONS AND CORRECT DETAILED
ANSWERS (VERIFIED ANSWERS) |ALREADY GRADED A+
Oxygen bottles that are properly secured in a rack or stand designed for
lifting/handling would be considered a critical rigging option. - ANSWER: false
There are three slings hanging from a hook. Each sling has the capacity of 2,000
pounds. What is the heaviest load that could be lifted using these slings if they were
attached to a single point? - ANSWER: 2,000 lbs
The minimum depth of thread engagement for a 1/2 inch eyebolt into a steel object
is: - ANSWER: 3/4"
Given a 1/2 in steel walled empty cylindrical tank that is opened at one end,
calculate its weight (round answer to the nearest hundred). - ANSWER: 1800
What markings are required on hoists? - ANSWER: the manufacturer, model number,
rated load, and re-inspection due date
Which of the following markings are required on lashing? - ANSWER: the reinspect
due date, rated load
A motor that weighs over 80 of the capacity of the rigging gear used in the rigging
operation is considered a critical rigging operation is considered a critical rigging
operation. - ANSWER: false
Increasing the sling angle from horizontal _______ the stress in the sling. - ANSWER:
decreases
The area of this triangle with dimensions given in feet is: - ANSWER: 24 sqft
What is the minimum grade of chain required for chain slings? - ANSWER: grade 80
Two people should be used to pull the hand chain of a manual chain hoist when it
gets too hard for on person to pull. - ANSWER: false
Sling angle stress could contribute to an overload even if the slings selected had
enough capacity to carry the total load weight. - ANSWER: true
Which of the following attachment points can be used at full capacity when pulled at
any angle from vertical? - ANSWER: swivel hoist rings
To find sling angle stress... - ANSWER: multiply the weight in the attachment point
with the angle factor
, Who is required to perfom an inspection prior to using rigging gear, and what is this
inspection called? - ANSWER: the user, pre-use inspection
Detailed written procedures are required for every rigging operation. - ANSWER:
false
The rigging operating envelope contains the rigging gear and miscellaneous
equipment covered by P-307 section 14, the load itself and... - ANSWER: the load
rigging path, the gear or equipment's supporting structure
When a load is left suspended unattended from a chain hoist it must be secured.
How is the chain hoist secured - ANSWER: the chain is tied off or pad locked
What is the efficiency of a knot or bend? - ANSWER: 75
Never bend a wire rope around a diameter _______ itself. - ANSWER: smaller than
To whom or to what are the majority of crane and rigging accidents attributed? -
ANSWER: personnel error
What is the name of the knot or hitch shown below? (blue rope) - ANSWER: clove
hitch
a straight-line hitch is good for _____ of a sling rated load? - ANSWER: 100%
What must be used to tighten a swivel hoist ring to the manufacturer's
requirements? - ANSWER: a torque wrench
Attachment point #1 is 6 feet from the center of gravity (CG) and attachment point
#2 is 3 feet from the center of gravity (CG). There is a 10,000 lbs load attached. What
is the correct equation to find the weight distribution for attachment point #1? -
ANSWER: 3 divided by 9 multiplied by 10,000 ( x 10,000)
It is ok to tie a know in or install a bolt into a chain sling leg to shorten the sling. -
ANSWER: false
When rigging gear covered by p-307 section 14 fails while suspended from a
structure and drops the load it is a: - ANSWER: rigging accident
Why must hoisting be stopped once the load is completely off the ground? -
ANSWER: to determine sling angle stress
Distorted or twisted rigging hardware must be: - ANSWER: removed from service
For all critical rigging operations, a supervisor must review on-site conditions and... -
ANSWER: conduct a pre-job briefing
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller maxmaxwellmm254. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $17.99. You're not tied to anything after your purchase.
Can Stuvia be trusted?
4.6 stars on Google & Trustpilot (+1000 reviews)
79373 documents were sold in the last 30 days
Founded in 2010, the go-to place to buy study notes for 14 years now