IEC Y1 S1 Final Questions And Answers 100% Verified.
49 views 0 purchase
Course
IEC Y1 S1
Institution
IEC Y1 S1
IEC Y1 S1 Final Questions And Answers 100% Verified.
Which of these is the symbol used for a 4-way switch? - correct answer. $4
Lighted handle toggle switches utilize a neon lamp that is illuminated when the switch is in the ___ position. - correct answer. OFF
The ungrounded...
IEC Y1 S1 Final 2024-2025 Questions And
Answers 100% Verified.
Which of these is the symbol used for a 4-way switch? - correct answer. $4
Lighted handle toggle switches utilize a neon lamp that is illuminated when the switch is
in the ___ position. - correct answer. OFF
The ungrounded conductor is often called the ___. - correct answer. hot
To convert a conventional duplex receptacle into a split-wired receptacle, the ___ is
removed. - correct answer. tab
Drawing ___ in Figure 112.415 is a framed locking (not key-lock) type switch. - correct
answer. IV
Refer to Figure 112.31. The light is ___. - correct answer. switched
Refer to Figure 128.110. Which of the drawings shows the (3-lamp) 2 x 4 luminaire
correctly connected? The "outboard" or 2-lamp ballast is to be controlled from switch #1
and the "inboard" or 1-lamp ballast is to be controlled from switch #2. - correct answer.
neither I nor II
The attachment cord cap (plug) shown in Figure 112.233 is connected to a table lamp.
Tab 2 is connected to the ___ conductor of the branch circuit when the cord cap is
plugged into a wall receptacle. - correct answer. grounded
What type of switch would you use to control a lighting load from one location only? -
correct answer. Single pole
SPST is an abbreviation for ___. - correct answer. Single Pole-Single Throw
The neutral conductor of a 120-volt circuit is referred to as the ___ conductor in the
NEC®. - correct answer. grounded
,The "hot" conductor of a circuit is referred to as the ___ conductor in the NEC®. -
correct answer. ungrounded
When installed as the neutral for a 120-volt circuit, the neutral is considered to be a
current-carrying conductor. - correct answer. True
Which of the following is an example of a "device?" - correct answer. GFCI receptacle
The color of the insulation of a neutral conductor that is 8 AWG shall be ___.
I. white II. bare III. gray - correct answer. I or III only
An insulated grounded conductor of 6 AWG or smaller shall be identified by a
continuous white or gray outer finish or by ___ continuous white stripes on other than
green insulation along its entire length. - correct answer. 3
What conductor in a circuit cannot be marked with a color of white or gray?
I. grounded II. equipment grounding III. ungrounded - correct answer. II & III only
Where installed in conduit, which of the following wire colors are permitted for "hots,"
travelers, and switch legs of a circuit?
I. black, red, and blue
II. brown, orange, and yellow
III. pink, black, and blue - correct answer. I or II or III
What conductor in a circuit can be marked with a green color?
I. grounded II. equipment grounding III. ungrounded - correct answer. II only
A luminaire has one blue wire and one white wire for field connection. When using cable
(NM, AC, or MC for example), the wire connected to the blue wire from the luminaire
___. - correct answer. must have colored insulation (not green or white or gray)
The Code section that addresses sensor (automatic) control of lighting in a restaurant
bathroom is ___. Select N/A (not applicable) if there is not a Code reference for this. -
correct answer. N/A
For stairway lighting, a typical installation is to install a 3-way switching system. For a
commercial building, ___ for stairway lighting control. - correct answer. there are no
NEC® requirements
Both lamps are to be controlled from the switch. Which of the connection diagrams
shown in Figure 112.511 is wired to operate correctly and does not violate 200.7 in the
NEC®? Type AC 12-2 and 12-3 cables are used between the outlet boxes. Future wall
access is available as required in NEC® 404.2(C)(2). - correct answer. IV only
, Refer to Figure 112.512. The lamp on the right is to be ON constantly (as a night light)
and the lamp on the left is to be controlled from the switch. Which of the connection
diagrams is wired to operate correctly and does not violate 200.7 in the NEC®? Type
AC 12-2 and 12-3 cables are used between the outlet boxes. Future wall access is
available as required in NEC® 404.2(C)(2). - correct answer. none of these
The lamp shown in Figure 122.514 is to be controlled from either switch. Which of the
following statements is true for Connection Diagram B? No wall access is available for
future cable installation.
I. It is wired to operate correctly.
II. The markings on the white conductor do not violate 200.7(C)(1) in the NEC®.
III. This installation meets the requirements of NEC® 404.2(C). - correct answer. I, II &
III
Which of the connection diagrams shown below is wired to operate correctly so that the
lamp can be controlled from any switch and the markings on the white conductors do
not violate NEC® 200.7? Future wall access is available as required in NEC®
404.2(C)(2). - correct answer. B.
Grounding is covered in Article ___ in the NEC®. - correct answer. 250
For lighting circuits, NEC® Section 404.2(C) requires a(n) ___ conductor to be provided
in each switch box or enclosure. - correct answer. grounded
Light switches (toggle switches) are rated for the maximum ___.
I. voltage II. current - correct answer. both I & II
A ___ switch is permitted to be used to control a 120-volt fluorescent lighting circuit. -
correct answer. either a or b
Is it permitted to control a 120-volt incandescent (tungsten filament) lighting circuit with
a switch rated for 15 A and 120-277 V? The circuit has 9 fixtures and each fixture will
have a 200 W, 120-V lamp installed in it. - correct answer. Yes
CO/ALR switches must be used when aluminum building wire is to be terminated. -
correct answer. True
A single-pole, double-throw switch has ___ screw terminals for the connection of
current-carrying circuit conductors. - correct answer. three
For the connection of current-carrying circuit conductors, a DPST switch has ___ screw
terminals. - correct answer. four
Refer to Figure 112.020. In Diagram II, are the conductors correctly connected so that
the light can be controlled from either switch? - correct answer. Yes
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller techgrades. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $14.49. You're not tied to anything after your purchase.
