ASE MLR Certification Test Questions With Verified Answers
4 views 0 purchase
Course
ASE MLR
Institution
ASE MLR
ASE MLR Certification Test Questions With
Verified Answers
Technician observes that the brake fluid level is at the "Min" mark in the master cylinder
reservoir. Tech A says that worn front pads could be the cause. Tech B says that a leak in the
brake hydraulic system could be the cause. Who is ...
ASE MLR Certification Test Questions With
Verified Answers
Technician observes that the brake fluid level is at the "Min" mark in the master cylinder
reservoir. Tech A says that worn front pads could be the cause. Tech B says that a leak in the
brake hydraulic system could be the cause. Who is right? - answer✔Both A and B
The tires of a vehicle are being rotated and balanced. Tech A says that the wheel weight retaining
clips must be matched to the rim profile. Tech B says that directional tires are rotated in a criss-
cross pattern. Who is right? - answer✔A only
When a shop fire cannot be immediately contained, the best thing to do is warn others in the
area, and: - answer✔Safely exit the building
A fully charged battery rated at 600 CCA, the ambient temperature is 70 degrees which of these
current and time periods should be used? - answer✔300 amps for 15 seconds
A vehicle's halogen headlamp bulbs are being replaced. Technician A says the glass part of the
bulb can only be handled with bare hands. Technician B says the headlamp may need to be
removed. Who is right? - answer✔B only
On a Metric Micrometer upper sleeve reading 5.0mm with lower sleeve reading 0.50mm and a
thimble reading of 0.01mm what is the overall reading? - answer✔0.728
The fuel filter on a fuel-injected vehicle is being replaced. Tech A says the fuel pressure should
be relieved before removing the filter. Tech B says that the arrow on the fuel filter should point
towards the fuel tank. Who is right? - answer✔A only
Which of these is an indication of air in the brake hydraulic system? - answer✔The brake pedal
feels low and spongy
Which of these cures in the absence of air? - answer✔Anaerobic
A grabbing brake condition can be caused by any of these EXCEPT: - answer✔Fluid
contaminated brake linings
When performing an oil filter change on a vehicle with a spin on oil filter, the technician must: -
answer✔Visually verify that the oil filter gasket is properly installed
A vehicle's battery prematurely fails. A charging system output test shows the generator
(alternator) is producing a constant 16.0 volts. This could indicate a failed: - answer✔Voltage
regulation
A transmission equipped with a filter is being serviced. When installing the new filter, the: -
answer✔Seal should be lubricated with transmission fluid
While inspecting the rear axle wheel studs on a rear-wheel drive vehicle, the technician observed
that one stud is damaged. Technician A says that all the wheel studs on the hub assembly should
be replaced. Technician B says that the thread pitch and diameter of the replacement stud must
be the same as the original. Who is right? - answer✔Both A and B
The three C's (concern, cause, and correction) are being reviewed on the repair order. Technician
A says that the customer's statement that the steering wheel shakes is the "correction".
Technician B says that a customer's statement about a puddle on the floor of the customer's
garage is the "cause". - answer✔Neither A nor B
A technician installs new brake pads on the front of a vehicle. Before the vehicle is removed
from the lift the technician should: - answer✔Pump the brake pedal until firm
When measuring parallelism of a disc brake rotor, a technician measures 0.002" variation beyond
specifications. The next step is to: - answer✔Determine rotor minimum "machine to" thickness
Technician A says that overfilling an automatic transmission can cause the transmission to leak.
Technician B says that under filling an automatic transmission can cause shifting problems. Who
is right? - answer✔Both A and B
While checking the fluid level in the front differential of a four-wheel drive vehicle, the lubricant
is found to be milky and overfull. Which of these could be the cause? - answer✔Water in the
lubricant
The customer's concern is low airflow from the dash vent. This could be the cause by: -
answer✔A restricted cabin filter
A customer states that the left front tire loses air. Any of these could be the cause EXCEPT: -
answer✔Excessive run out in the wheel
Which of these agencies enforces commercial workplace safety and environmental health
regulations? - answer✔OSHA
Technician A says that rosin-core solder should be used when soldering electrical connections.
Technician B says that a crimp and shrink connector can be used when repairing electrical
wiring. Who is right? - answer✔A only
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller Brainbarter. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $10.49. You're not tied to anything after your purchase.
