Exam (elaborations)
ASE A1(Engine Repair) CUMULATIVE PRACTICE TEST QUESTIONS AND ANSWERS.
- Course
- Institution
ASE A1(Engine Repair) CUMULATIVE PRACTICE TEST QUESTIONS AND ANSWERS.
[Show more]
Content preview
ASE A1(Engine Repair) CUMULATIVE PRACTICETEST QUESTIONS AND ANSWERS.
A cooling system is being checked with a pressure tester. the gauge
pressure rises when the engine is started.
A says this could be caused by a crack in the combustion chamber.
B says this could be caused by clogged tubes in the radiator
A
B
Both
Neither
Verified Answer -A
A clogged radiator would not cause this
While replacing a faulty heater core hose, a technician discovers that the
hose is stubbornly stuck to the heater core fitting. to remove the hose, he
should:
-pierce the hose with a screwdriver and try to pull it off the fitting
-use a pair of pliers to loosen the hose
-pry behind the edge of the hose to loosen it
-cut the hose off at the fitting and slit the remaining piece
Verified Answer -cut the hose off at the fitting and slit the remaining
piece
,while cleaning a pleated paper-type air filter element, the air gun should
be held:
away from the outside of the air filter element
directly against the outside of the air filter element
directly against the inside of the air filter element
away from the inside of the air filter element
Verified Answer -away from the inside of the air filter element
~when cleaning a pleated paper-type air filter element using compressed
air, hold the air gun tip about 6 inches from the inside of the filter
element
-air should be blown from the inside out to remove particles, and air
forced into the filter are too short of a distance may damage the filter.
all of the following statements regarding manifold heat control valves are
true EXCEPT:
- a manifold heat control valve improves fuel vaporization in the intake
manifold especially when the engine is cold
- a manifold heat control valve stuck in the closed position causes a loss
of engine power
- a manifold heat control valve stuck in the open position may cause an
acceleration stumble
,- a manifold heat control valve stuck in the closed position reduces intake
manifold temperature
Verified Answer -a manifold heat control valve stuck in the closed
position reduces intake manifold temp
~the exhaust manifold on carbureted and throttle body injected engines
may be equipped with a manifold heat control valve. if the manifold heat
control valve is stuck open or fails to close when the engine is cold, the
engine may stumble during acceleration. if the valve is stuck in the closed
position, engine power will be reduced and the intake manifold will
overheat.
A says an intake manifold vacuum leak may cause a cylinder misfire with
the engine idling.
B says an intake manifold vacuum leak may cause a cylinder misfire
during hard acceleration...
A
B
Both
Neither
Verified Answer -A
an intake manifold vacuum leak at idle may cause a cylinder misfire
condition. an intake manifold vacuum leak will not cause a misfire
condition during hard acceleration when the vacuum is lower. manifold
vacuum is reduced during acceleration. Therefore, the leak would not
contribute to cylinder misfire
, the hose from the positive crankcase ventilation valve to the intake
manifold is restricted. this problem could result in
an acceleration stumble
oil accumulation in the air cleaner
engine surging at high speed
engine detonation during acceleration
Verified Answer -oil accumulation in the air cleaner
- a pcv valve stuck open may casue acceleration stumble
-restricted pcv hose would not cause the engine to surge at high speed,
nor would it lead to engine detonation
when installing a starter motor, shims may be required by some
manufacturers to adjust the gap between the starter pinion gear and
flywheel ring gear. adding a 0.015 inch shim between the starter motor
and the engine block will:
decrease the clearance by 0.005
decrease the clearance by 0.015
increase the clearance by 0.010
increase the clearance by 0.005
Verified Answer -increase the clearance by 0.005.
~adding a 0.015 inch shim will increase clearance by 0.05 inch
reduced turbocharger boost pressure may be caused by a:
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller saraciousstuvia. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $18.49. You're not tied to anything after your purchase.
Can Stuvia be trusted?
4.6 stars on Google & Trustpilot (+1000 reviews)
67474 documents were sold in the last 30 days
Founded in 2010, the go-to place to buy study notes for 14 years now