Garantie de satisfaction à 100% Disponible immédiatement après paiement En ligne et en PDF Tu n'es attaché à rien
logo-home
INSTRUMENT TECH NCCER EXAM QUESTIONS WITH DETAILED ANSWERS // 100% GUARANTEED PASS A+ GRADED $12.99
Ajouter au panier

Examen

INSTRUMENT TECH NCCER EXAM QUESTIONS WITH DETAILED ANSWERS // 100% GUARANTEED PASS A+ GRADED

1 vérifier
 1 fois vendu
  • Cours
  • NCCER
  • Établissement
  • NCCER

1) When is the BEST time to document each loop check for commissioning ? A. Prior to the start of inspection B. When all test and inspection activities are complete C. When updating information on a daily basis D. At the time each test is completed - ANS D. At the time each test is complet...

[Montrer plus]

Aperçu 4 sur 35  pages

  • 8 octobre 2024
  • 35
  • 2024/2025
  • Examen
  • Questions et réponses
  • NCCER
  • NCCER

1  vérifier

review-writer-avatar

Par: austinlopez • 4 semaines de cela

reply-writer-avatar

Par: Studyclock • 4 semaines de cela

Thank you for the review and success in your Exams.

avatar-seller
Studyclock
ck
lo
yc
INSTRUMENT TECH
NCCER EXAM QUESTIONS
ud

WITH DETAILED
ANSWERS // 100%
st



GUARANTEED PASS A+
GRADED

,1) When is the BEST time to document each loop check for commissioning ? A. Prior to the start
of inspection
B. When all test and inspection activities are complete
C. When updating information on a daily basis
D. At the time each test is completed - ANS D. At the time each test is completed (INST
LVL4)(12410-16/ Section 3.2.0)

2) Teflon paste must not be used on :
A. Nitrogen service
B. Natural gas service




ck
C. Water service
D. Oxygen service - ANS D. Oxygen service (INST LVL 1 )(12109-14/Section 2.1.1)

3) A 24VDC power supply is not working . With your multimeter you verify no DC voltage . On
the 120VAC input you measure 120V between hot and ground , and 72V between hot and


B. Lost the hot
C. Lost the neutral
D. Lost the fuse - ANS C. Lost the neutral
lo
neutral . What is the most likely cause of this ?
A. Lost the ground
yc
4) Gain increase when tube :
A. Back bends are made
B. Bend radius increases
C. Size decreases
ud

D. Long radius elbows are used - ANS B. Bend radius increases (INST LVL 2)(12302-15
section 2.1.1)

5) A temperature measuring device that produces a voltage as the temperature changes is a /
an :
A. RTD
st


B. Thermistor
C. Thermometer
D. Thermocouple - ANS D. Thermocouple (INST LVL 2) (12110-15 section 1.2.2)

6) A pressure piping code is found in :
A. ANSI B 31.1
B. NEC 690 .
C. OSHA1910 .
D. ISA S 5.1 - ANS A. ANSI B 31.1

7) When marking tubing for cutting , the preferred method is

,A. Scribe a mark into the tube with a sharp object .
B. Mark the tube with a grease pencil
C. Mark the tube with a felt tip pen
D. Mark the tube with a crayon - ANS C. Mark the tube with a felt tip pen

8) An example of direct measurement indicator is a :
A. Pressure gauge
B. Bulb thermometer
C. Sight glass
D. Flowmeter - ANS C. Sight glass

9) On the image , how many hand valves are installed on Tank 1201C




ck
A. 1
B. 2
C. 3
D. 4 - ANS C. 3




B. Stimulate an input
C. Verify that there is a problem
lo
10) What is the first step in troubleshooting a problem in a system ?
A. Turn off power to the instrument


D. Stimulate an output - ANS C. Verify that there is a problem
yc
11) Where can the appropriate elevation of an instrument be found ?
A. Location drawing
B. P & ID
C. Flow diagram
ud

D. Loop drawing - ANS A. Location drawing

12) Chemical cleaning of tubing attached to instruments may cause damage to sensor
A. Electronics
B. Paint
C. Elements
st


D. Bolts - ANS C. Elements

13) When making 90 - degree tubing bend , allowance for springback should be : A. 6 to 8
degrees
B. 4-5 degrees
C. 1 to 3 degrees
D. 0 degrees - ANS C. 1 to 3 degrees

14) Cable shields should be connected to the :
A. Signal ground reference point
B. Ground at each accessible location

, C. First accessible grounding electrode
D. Raceway or cable tray in which the cable is routed - ANS B. Ground at each accessible
location

15) An employee de energizes a piece of equipment by removing the power plug from the outlet
. If the employee continues to hold on to the power plug once removed , this employee is said to
have what type of control over the energy potential ?
A. Isolation control
B. Lockout tagout
C. Exclusive control
D. Remote control - ANS C. Exclusive control




ck
16) A compressor keeps blowing a PSV for troubleshooting a technician should start looking at
A. Power switch setting
B. Pressure switch deadband
C. Level switch setting
D. Float swich deadband - ANS B. Pressure switch deadband


gas is labeled as
A. A
B. B
lo
17) In the figure provided the pipe line that carries working process fluid such as steam water or
yc
C. C
D. D - ANS A. A

18) A heat reactive dryer is producing damp instrument air what could be a simple fix
A. Replace desiccant
ud

B. Change to a different desiccant
C. Adjust the cycle time
D. Add a second set of dryers - ANS C. Adjust the cycle time

19) Type J thermocouple extension wire is
A. White & red
st


B. Yellow & red
C. Blue & red
D. Green & red - ANS A. White & red

20) Which of the following gases should be used to purge tubing and pipe after cleaning
A. argon
B. Air
C. Nitrogen
D. helium - ANS C. Nitrogen

21) When pressure testing , the required documentation includes :

Les avantages d'acheter des résumés chez Stuvia:

Qualité garantie par les avis des clients

Qualité garantie par les avis des clients

Les clients de Stuvia ont évalués plus de 700 000 résumés. C'est comme ça que vous savez que vous achetez les meilleurs documents.

L’achat facile et rapide

L’achat facile et rapide

Vous pouvez payer rapidement avec iDeal, carte de crédit ou Stuvia-crédit pour les résumés. Il n'y a pas d'adhésion nécessaire.

Focus sur l’essentiel

Focus sur l’essentiel

Vos camarades écrivent eux-mêmes les notes d’étude, c’est pourquoi les documents sont toujours fiables et à jour. Cela garantit que vous arrivez rapidement au coeur du matériel.

Foire aux questions

Qu'est-ce que j'obtiens en achetant ce document ?

Vous obtenez un PDF, disponible immédiatement après votre achat. Le document acheté est accessible à tout moment, n'importe où et indéfiniment via votre profil.

Garantie de remboursement : comment ça marche ?

Notre garantie de satisfaction garantit que vous trouverez toujours un document d'étude qui vous convient. Vous remplissez un formulaire et notre équipe du service client s'occupe du reste.

Auprès de qui est-ce que j'achète ce résumé ?

Stuvia est une place de marché. Alors, vous n'achetez donc pas ce document chez nous, mais auprès du vendeur Studyclock. Stuvia facilite les paiements au vendeur.

Est-ce que j'aurai un abonnement?

Non, vous n'achetez ce résumé que pour $12.99. Vous n'êtes lié à rien après votre achat.

Peut-on faire confiance à Stuvia ?

4.6 étoiles sur Google & Trustpilot (+1000 avis)

63950 résumés ont été vendus ces 30 derniers jours

Fondée en 2010, la référence pour acheter des résumés depuis déjà 15 ans

Commencez à vendre!
$12.99  1x  vendu
  • (1)
Ajouter au panier
Ajouté