INTERNACHI HOME INSPECTOR – 1 Exam | Questions and Correct Answers | Latest Update 2024/2025 | 100% PASS
1 view 0 purchase
Course
Internachi mold
Institution
Internachi Mold
INTERNACHI HOME
INSPECTOR – 1 Exam |
Questions and Correct
Answers | Latest Update
2024/2025 | 100% PASS
The upper edge of a masonry chimney cleanout should be at least ____
inches below the lowest inlet opening. - Answer -6
The minimum slope for a composition-shingle roof is ____. - Answe...
INTERNACHI HOME
INSPECTOR – 1 Exam |
Questions and Correct
Answers | Latest Update
2024/2025 | 100% PASS
The upper edge of a masonry chimney cleanout should be at least ____
inches below the lowest inlet opening. - Answer -6
The minimum slope for a composition-shingle roof is ____. - Answer -
2:12
Wood rot may be found when the wood's moisture content is above
____. - Answer -20%
InterNACHI estimates that of the 45 million existing decks, only _____
are completely safe. - Answer -40%
InterNACHI estimates that of the 45 million existing decks, only _____
are completely safe. - Answer -40%
Many builders use common "1/2-inch wood sheathing, which has an R-
value of ______. - Answer -0.6
,The U.S. government has established a minimum rating for furnaces of
_________. - Answer -78%
The minimum efficiency rating for furnaces is ___________. - Answer -
78%
A home must be ventilated to let out moisture. More than
___________ of the water used to water plants eventually enters the
air. - Answer -99%
Ramps should not have a slope greater than a ___ unit vertical in 12
units horizontal. - Answer -1
Traps should be level in relation to a water seal. Traps should have a
water seal of at least _____ inches. - Answer -2
In a solid wood floor joist, a bored hole should be at least ___ inches
from the top or bottom edge. - Answer -2
For purposes of anchoring to the foundation wall, there should be at
least ______ bolts per plate section. - Answer -2
In a solid wood floor joist, a bored hole should be at least ___ inches
from the top or bottom edge. - Answer -2
Masonry chimneys should extend at least ____ feet higher than any
portion of a building within 10 horizontal feet. - Answer -2
On roof slopes greater than 4&12 modern standards call for
underlayment courses to overlap horizontally a minimum of _____
inches. - Answer -2
The standpipe and trap for an automatic clothes washer should be at
least ____ inches in diameter. - Answer -2
,An attic with an area of 600 square feet with ridge and soffit vents
should have a total vent area of _____ square feet - Answer -2
A clearance gap of ___ inches is required between a manufactured
chimney and combustibles - Answer -2
If a roof ridge is closer than 10 feet to a chimney, the stack should be
____ feet higher - Answer -2
An attic with an area of 600 square feet with ridge and soffit vents
should have a total vent area of _____ square feet - Answer -2
A clearance gap of ___ inches is required between a manufactured
chimney and combustibles - Answer -2
If a roof ridge is closer than 10 feet to a chimney, the stack should be
____ feet higher - Answer -2
A proper chimney crown should be constructed of a Portland cement-
based mixture and cast or formed so that it provides an overhang
projecting beyond all sides of the chimney by a minimum of _____
inches. - Answer -2
House framing components should be at least ____ inches away from
the chimney wall - Answer -2
A proper masonry chimney cap should be constructed of a Portland
cement-based mixture and cast or formed so it provides an overhang
projecting beyond all sides of the chimney by a minimum of _____
inches - Answer -2
House framing components should be at least ____ inches away from
the chimney wall - Answer -2
, A proper masonry chimney cap should be constructed of a Portland
cement-based mixture and cast or formed so it provides an overhang
projecting beyond all sides of the chimney by a minimum of _____
inches - Answer -2
Felt underlayment on tile roofs with a pitch between 3:12 and 4:12
should have a minimum _____-inch headlap. - Answer -2
Felt underlayment on tile roofs with a pitch of 4:12 or greater should
have a minimum _____-inch headlap. - Answer -2
Felt underlayment on tile roofs with a pitch of 4:12 or greater should
have a minimum _____-inch headlap - Answer -2
Open electrical service conductors and multi-conductor cables that are
not installed in a raceway or provided with an approved overall outer
jacket should have a clearance of at least _____ feet from the sides of
doors, porches, decks, stairs, ladders, fire escapes and balconies, and
from the sides and bottoms of operable windows. - Answer -3
The minimum height of a masonry chimney should be _____ feet. -
Answer -3
Open electrical service conductors and multi-conductor cables that are
not installed in a raceway or provided with an approved overall outer
jacket should have a clearance of at least _____ feet from the sides of
doors, porches, decks, stairs, ladders, fire escapes and balconies, and
from the sides and bottoms of operable windows. - Answer -3
Service drops should not pass closer than ____ feet over the ridge of a
conventionally pitched roof. - Answer -3
A typical chimney is a minimum of ____ feet high - Answer -3
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller mercylynneh. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $12.49. You're not tied to anything after your purchase.
