TSSA 4th Part B - Unit 9 Exam
Latest Update
(4-113-1.9) The two major types of compression refrigeration systems are: - Answer
Indirect and Direct
(4-116-1.4) The safety head of a refrigeration compressor is designed to: - Answer
Relieve pressure due to liquid in the cylinder
(4-120-1.2) A pressure relief device on a refrigeration system shall have sufficient
capacity to prevent the pressure in the pressure vessel from rising more than _____
above the setting of the pressure relief device. - Answer 0.1
(4-117-2.1) The amount of water used in an evaporative condenser is only a small
percentage of that used in a water-cooled condenser of the same capacity, because -
Answer The cooling water evaporates, removing far more heat per kilogram of system
coolant.
(4-116-int.2) The three main classifications of refrigeration compressors are: - Answer
Reciprocating, rotary, and centrifugal
(4-117-2.2) Which of the following statements about double tube refrigeration
condensers is true? - Answer Water flows in the inner tube in the opposite direction of
the flow of refrigerant.
(4-114-1.6) Ammonia, as well as being toxic, is also: - Answer Flammable
4-117-1.7) All refrigeration evaporators: - Answer boil liquid refrigerant at low pressure
and low temperature
What is the Permissible Exposure Limit for R-717? - Answer 50 ppm
(4-116-1.3) Which of the following is NOT considered a rotary refrigeration compressor
design? - Answer Centrifugal
(4-123-1.3) In an Ammonia Absorption refrigeration system, what is used as the
absorbent? - Answer Water
(4-122-2.1) The safety control of a centrifugal compressor, that ensures the compressor
only starts under a no-load condition, is called the - Answer Vane closed switch
(4-123-2.4) The absorber in the lithium bromide refrigeration system is equipped with a
pump - Answer To speed the absorption of water vapour
An example of a high leak probability system is a: - Answer a direct expansion system
(4-118-3.2) The low oil pressure cut-off switches of a mechanical refrigeration system -
, Answer shut down the compressor when the oil pressure drops below the minimum
required value
(4-117-2.4) The refrigeration condenser design that requires chemical cleaning,
because it cannot be mechanically cleaned, is the: - Answer Shell and coil condenser
(4-122-2.3) If the chilled water temperature drops approximately 2.5-3°C below the
chilled water temperature set point, the chilled water low temperature cut out will: -
Answer Shut down the compressor
(4-122-1.1) Which of the following steps is NOT part of a start-up of a reciprocating or
rotary compressor refrigerating system? - Answer Valves in pressure piping should be
closed
(4-114-1.13) The ideal refrigerant should: - Answer Have a low ozone depleting potential
and a low global warming potential
(4-120-1.7) The accessory that maintains efficient heat transfer by collecting oil before it
coats the tubes of the condenser is called: - Answer An oil separator
(4-118-3.1) The CSA B52 code requires that ____________________ shall be provided on all
systems operating above atmospheric pressure. - Answer pressure limiting devices
(4-117-1.8) Of the following refrigeration system evaporators, the ___________
evaporators require the largest refrigerant charge. - Answer Flooded
(4-114-1.3) R-744 is non-toxic and non-flammable. Which safety group does it belong to?
- Answer Group A1
(4-123-1.2) Which of the following is not found on the low side of an ammonia absorption
refrigeration system? - Answer Generator
(4-113-1.2) Heat that causes an increase in temperature, is called _____ heat: - Answer
Sensible
(4-114-2.1) Which of the following is NOT a physical property of refrigerants? - Answer
Corrosiveness
(4-119-1.1) The most widely used refrigerant metering device, which consists of a
pressure-sensitive bellows or diaphragm connected to a temperature sensing bulb, is
the - Answer thermostatic expansion valve
(4-123-1.4) In an ammonia absorption refrigeration system, the _____ ammonia is
absorbed by the _____ aqua. - Answer Vapourized, weak
(4-123-2.2) In the lithium bromide refrigeration system, what is the function of the
concentrator (generator)? - Answer To increase the absorbency potential of used
absorbent
(4-113-1.6) In a closed vessel, the boiling point of a liquid can be raised by: - Answer
Voordelen van het kopen van samenvattingen bij Stuvia op een rij:
Verzekerd van kwaliteit door reviews
Stuvia-klanten hebben meer dan 700.000 samenvattingen beoordeeld. Zo weet je zeker dat je de beste documenten koopt!
Snel en makkelijk kopen
Je betaalt supersnel en eenmalig met iDeal, creditcard of Stuvia-tegoed voor de samenvatting. Zonder lidmaatschap.
Focus op de essentie
Samenvattingen worden geschreven voor en door anderen. Daarom zijn de samenvattingen altijd betrouwbaar en actueel. Zo kom je snel tot de kern!
Veelgestelde vragen
Wat krijg ik als ik dit document koop?
Je krijgt een PDF, die direct beschikbaar is na je aankoop. Het gekochte document is altijd, overal en oneindig toegankelijk via je profiel.
Tevredenheidsgarantie: hoe werkt dat?
Onze tevredenheidsgarantie zorgt ervoor dat je altijd een studiedocument vindt dat goed bij je past. Je vult een formulier in en onze klantenservice regelt de rest.
Van wie koop ik deze samenvatting?
Stuvia is een marktplaats, je koop dit document dus niet van ons, maar van verkoper Flat. Stuvia faciliteert de betaling aan de verkoper.
Zit ik meteen vast aan een abonnement?
Nee, je koopt alleen deze samenvatting voor $8.99. Je zit daarna nergens aan vast.