When starting a centrifugal pump that is part of a manifold with no check valves. - ANSWER You should open the suction valve, start the pump and open the discharge valve slowly.
A valve inserted in a water line between the corporation stop and the water meter is generally called. - ANSWER Curb c...
When starting a centrifugal pump that is part of a manifold with no check valves. - ANSWER You should
open the suction valve, start the pump and open the discharge valve slowly.
A valve inserted in a water line between the corporation stop and the water meter is generally called. -
ANSWER Curb cock
To check sheave wear. - ANSWER Measure each groove angle
Variable pitch sheaves may be used in some cases to provide which of the following types of speed
changes - ANSWER small
Absolute pressure is gauge - ANSWER Pressure plus 14.7 psi
Which of the following best describes the basic types of sprinklers systems in a building - ANSWER
Standard wet-type system, Standard dry-type system,
A deluge system
Power equals - ANSWER Force x distance divided by time
Torches should be inspected for leakage at the - ANSWER Tip,
Valves,
Hose connections
Smoke detection is usually accomplished by using either photo-electric scanning, ionization chambers or
smoke reflection devices? - ANSWER True
, If a coupling is not properly aligned - ANSWER 1. Will fail quicker
2. Wear out equipment and the bearing
To protect a pump and motor against slight misalignment, they are often connected by a. - ANSWER
Flexible coupling
A weld used to fill a corner, as in a lap joint or a t joint, is called a? - ANSWER Fillet weld
Greases are classified as to their mobility and oil content by the? - ANSWER S.A.E.
Continual problems with belt turnover are likely to be caused by? - ANSWER Improper installation
technique
The scale of a working drawing can be determined by? - ANSWER The scale will be indicated on the
drawing
A _______ is a direct or indirect connection which may permit waste sewage or other non-potable water
to flow into a potable water source or supply? - ANSWER Cross connection
Traps are installed to prevent ________ from entering the structure? - ANSWER sewer gas, offensive
odors, vermin, all of the above.
The main purpose of lubrication is usually to? - ANSWER Reduce friction and wear.
When installing a p-trap, the vertical distance from the fixture to the ________ may not exceed 24". -
ANSWER Trap outlet
A gate valve would be used in an application where you need to control the flow of a fluid. - ANSWER
False, Globe valve to control.
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller shantelleG. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $9.99. You're not tied to anything after your purchase.