26107-hand bending questions
with 100% correct answers
Which of the following should be used to cut EMT? - -Hacksaw
- A dye is used to do what? - -Cut threads in a pipe
- . Which of the following eliminates wrinkling or flattening when bending
PVC - -Plug set
- . A radius of a circle is defined as what? - -The distance from the center to
the edge of the circle
- Which of the following can be used to bend IMC? - -Hickey
- A pocket knife can be used to deburr what? - -PVC
- The formula pi(d) is used to calculate what? - -Circumference
- Two junction boxes are each located on different walls, 12 inches from the
same corner. Given a 90-degree bend with a take-up of 6 inches and a gain
of 2-1/4 inches, what is the developed length of the conduit between them? -
-21-3/4 inches
- Two 90-degree bends in the same piece of conduit are required for a(n)? -
-Back-to-back bend
- When creating an offset using 10-degree bends (with a multiplier of 6) to
cross a 6-inch obstruction, the distance between the bends is? - -36 inches
- Which of the following is most commonly used to cut RMC and IMC? - -Pipe
cutter
- Which of the following describes circumference? - -The distance around a
circle
- A right triangle is any triangle with what? - -A 90-degree angle
- Gain is best describes as the what? - -Distance saved by the arc of a bend
- The developed lengh of a bend is equal to the what? - -Some of the
horizontal and the vertical distances minus the gain
-
with 100% correct answers
Which of the following should be used to cut EMT? - -Hacksaw
- A dye is used to do what? - -Cut threads in a pipe
- . Which of the following eliminates wrinkling or flattening when bending
PVC - -Plug set
- . A radius of a circle is defined as what? - -The distance from the center to
the edge of the circle
- Which of the following can be used to bend IMC? - -Hickey
- A pocket knife can be used to deburr what? - -PVC
- The formula pi(d) is used to calculate what? - -Circumference
- Two junction boxes are each located on different walls, 12 inches from the
same corner. Given a 90-degree bend with a take-up of 6 inches and a gain
of 2-1/4 inches, what is the developed length of the conduit between them? -
-21-3/4 inches
- Two 90-degree bends in the same piece of conduit are required for a(n)? -
-Back-to-back bend
- When creating an offset using 10-degree bends (with a multiplier of 6) to
cross a 6-inch obstruction, the distance between the bends is? - -36 inches
- Which of the following is most commonly used to cut RMC and IMC? - -Pipe
cutter
- Which of the following describes circumference? - -The distance around a
circle
- A right triangle is any triangle with what? - -A 90-degree angle
- Gain is best describes as the what? - -Distance saved by the arc of a bend
- The developed lengh of a bend is equal to the what? - -Some of the
horizontal and the vertical distances minus the gain
-
