Module 26107-20 Exam Hand Bending/15
Questions with Solutions
1. The distance from the center point to the edge of a circle is known as the -
-radius
- 2. Which of the following eliminates wrinkling or flattening when bending
PVC? - -Plug set
- 3. A circle with a radius of 15" has a circumference of - -94.2
- 4. Circumference can be calculated using the formula - -Pi x D
- 5. Gain is best described as the - -Distance saved by the arc of 90 bend
- 6. The distance around a circle is known as the - -Circumference
- 7. When creating an offset using 30° bends (with a multiplier of 2.0) to
cross a 6-inch obstruction, the distance between bends is - -12 inches
- 8. Two junction boxes are each located on different walls, 18" from the
same corner. Given a 90° bend with a take-up of 6" and a gain of 4", what is
the developed length of the conduit between them? - -32 inches
- 9. Which of the following should be used to cut EMT? - -Hacksaw
- 10. RMC, IMC, and EMT are available in standard lengths of - -10 ft
- 11. The first step in reaming conduit is to - -Secure the conduit pipe in a
vise
- 12. Which of the following is most commonly used to cut RMC and IMC? - -
Pipe cutter
- 13. A pocket knife can be used to deburr - -PVC
- 14. Forming PVC in the field requires the use of a(n) - -Hot box
- 15. A die is used to - -Cut threads into conduit
-
Questions with Solutions
1. The distance from the center point to the edge of a circle is known as the -
-radius
- 2. Which of the following eliminates wrinkling or flattening when bending
PVC? - -Plug set
- 3. A circle with a radius of 15" has a circumference of - -94.2
- 4. Circumference can be calculated using the formula - -Pi x D
- 5. Gain is best described as the - -Distance saved by the arc of 90 bend
- 6. The distance around a circle is known as the - -Circumference
- 7. When creating an offset using 30° bends (with a multiplier of 2.0) to
cross a 6-inch obstruction, the distance between bends is - -12 inches
- 8. Two junction boxes are each located on different walls, 18" from the
same corner. Given a 90° bend with a take-up of 6" and a gain of 4", what is
the developed length of the conduit between them? - -32 inches
- 9. Which of the following should be used to cut EMT? - -Hacksaw
- 10. RMC, IMC, and EMT are available in standard lengths of - -10 ft
- 11. The first step in reaming conduit is to - -Secure the conduit pipe in a
vise
- 12. Which of the following is most commonly used to cut RMC and IMC? - -
Pipe cutter
- 13. A pocket knife can be used to deburr - -PVC
- 14. Forming PVC in the field requires the use of a(n) - -Hot box
- 15. A die is used to - -Cut threads into conduit
-
