100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
IYRS Electrical ABYC Exam Questions and Answers $10.49   Add to cart

Exam (elaborations)

IYRS Electrical ABYC Exam Questions and Answers

 8 views  0 purchase
  • Course
  • ABYC Electrical
  • Institution
  • ABYC Electrical

IYRS Electrical ABYC Exam Questions and Answers

Preview 2 out of 6  pages

  • November 12, 2024
  • 6
  • 2024/2025
  • Exam (elaborations)
  • Questions & answers
  • ABYC Electrical
  • ABYC Electrical
avatar-seller
millyphilip
IYRS Electrical ABYC Exam Questions
and Answers

The minimum amp circuit breaker that should be used to protect a 120V water heater
circuit with a 1600-watt element would be rated at ________ amps - Answers -15

When testing for excessive EMF emission near a conductor or appliance, the tool of
choice is a - Answers -Gauss Meter

The primary problem with using a series circuit to supply multiple loads is that - Answers
-voltage drop across each load will be excessive

the most common electrical circuit problem in marine applications is - Answers -
unwanted open

the primary by-product of excessive electrical resistance is - Answers -heat

the tool of choice today for tracing shorted and open circuits is the: - Answers -TDR

What material is recommended for clamping conductors over engines and moving
machinery according to the ABYC - Answers -Metal

according to ABYC acceptable minimum clearance for routing wire near a dry exhaust
section is - Answers -9 inches (225 mm)

The maximum number of terminals allowed to be attached to any one terminal stud
based on ABYC is - Answers -4

How much current should flow through the
DC grounding conductor in a 25-amp DC motor circuit - Answers -0 amps

conductors of #10 AWG and larger shall be permitted to be connected in parallel
______ - Answers -Where the ampacity of each individual conductor is sufficient to
carry the entire load current shared by the parallel conductors

A technician is installing the cable run from the batteries to the main DC panelboard on
a boat aspart of a refit. The boat has a 12-volt system, and the distance from the panel
to the batteries is 15 ft (approximately 3 m).The maximum current draw from the panel
is calculated at 90 amps.What gauge cable should be used at a minimum to maintain
Standards compliance? - Answers -0 AWG

, 8. DC grounded conductors on new boats that are also equipped with AC systems
should use _________ insulation. - Answers -yellow

the maximum spacing for cable run support based on ABYC is - Answers -16 inches
(400 mm)

the smallest gauge cable allowed for unsheathed wire runs through the boat is -
Answers -16 AWG

The maximum sustained charging voltage acceptable to some gel cell battery
manufacturers is - Answers -14.1

Sheathed, ungrounded conductors connected directly to a battery must have
overcurrent protection devices located within _______ of connection to the battery -
Answers -40 Inches

on a battery where a hydrometer can be used, a cell reading of 0.050 points of a
specific gravity below all of the other cells in the battery may indicate - Answers -A bad
cell and battery replacement needed

some battery manufacturers will only consider replacement on batteries whose
condition has been determined by use of a - Answers -conductance tester

Tech A says that sealed batteries can be mounted anywhere in the boat where space
can be found.TechBsays that consideration should be given to ventilation and the
mounting surfaces and the surrounding area near the battery, and their resistance to
acid attack.Which technician is correct? - Answers -tech B

Minimum battery reserve capacity allowed based on ABYC standards is - Answers -90
Minutes

Based on ABYC standards, cable attachment to batteries with wing type nuts is allowed
as long as the wire gauge does not exceed - Answers -8 AWG

Traditional battery load testing methods dictate that a load equivalent to _____ % of the
battery's CCA rating be placed on the battery - Answers -100

The metallic case of the battery charger should be connected to the - Answers -DC
grounding system

Tech A says that voltage supplied to the rotor controls alternator output voltage. Tech B
says that the alternator output is proportional to rotor voltage. Which Technician is
correct? - Answers -Both Techs

A voltage regulator controls which of the following? - Answers -Alternator field Voltage

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller millyphilip. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for $10.49. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

67866 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy study notes for 14 years now

Start selling
$10.49
  • (0)
  Add to cart