CSLB Class B General Contractor's License - Building's Exam: Core Trades (Part 2) Questions and 100% answers!
2 views 0 purchase
Course
CSLB B
Institution
CSLB B
CSLB Class B General Contractor's License - Building's Exam: Core Trades (Part 2) Questions and 100% answers!
3 inches - ANSWER What is the minimum drain pipe size for the toilet in a residential home?
B) Fire protection contractor - ANSWER Who is licensed to install residential fir...
CSLB Class B General
Contractor's License - Building's
Exam: Core Trades (Part 2)
Questions and 100% answers!
A
VI
TU
3 inches - ANSWER
residential home?
What is the minimum drain pipe size for the toilet in a
IS
B) Fire protection contractor - ANSWER Who is licensed to install residential fire
sprinkler systems?
M
A) Plumbing contractor
B) Fire protection contractor
O
C) General Building contractor
D) Pipeline contractor
A
C) Clean the surface using a power tool - ANSWER When brazing or soldering gas
N
pipes during the installation of water heaters, what is the best way to prepare the pipe?
A) Clean it with water
JP
B) Blow into the pipe using your lungs
C) Clean the surface using a power tool
D) Use a pressurized air canister
D) Endless rope lift - ANSWER Which personal lift is not acceptable?
A) Scissor
B) Boom
C) Manual
,D) Endless rope lift
B) To soften PVC pipe before applying PVC cement - ANSWER What is the purpose
of PVC primer?
A) To glue PVC pipes to other materials
B) To soften PVC pipe before applying PVC cement
C) To prevent electrical shock
D) To help solder conduit or piping
A
C) Flashing
VI
(Leaks are most common when two surfaces meet or around fenestration. Leaks are
most prominent in valley flashing and improperly installed window flashing.) - ANSWER
TU
What is the most common location to find a roof leak?
A) Attic
B) Shingles
C) Flashing
IS
D) Collar tie
C) Pipe supports come into contact with metal piping
M
(Mainly due to water hammer.) - ANSWER What is the most common reason for
O
noise in piping when a water fixture is turned on or off?
A) Hot water was used
A
B) Cold water was used
C) Pipe supports come into contact with metal piping
N
D) The walls are not up to code causing pipe failure
JP
C) Brass type - ANSWER If you send your employee to purchase a 2-inch water
supply valve and they return with a 1.5-inch supply valve, then what is the proper
composition of the valve?
A) The casing must be made of plastic
B) The employee must return and purchase a wrought iron valve
C) Brass type
D) The connection must be silver and body made of iron
, 10 - ANSWER When penetrating a roof with an exhaust, the exhaust must be no
closer than _____ feet to any air intake or openable window.
A) Class A - ANSWER Which roof assembly has the best fire rating?
A) Class A
B) Class B
C) Class I
D) Class III
A
D) Use of materials that are compatible with the type of pipe and fitting materials -
VI
ANSWER What does material compatibility refer to when installing alternate water
sources in existing plumbing systems?
TU
A) Plumbing fixtures have to come from the same manufacturer
B) Only the couplings must be made of metal
C) All plumbing connections must be soldered or brazed
D) Use of materials that are compatible with the type of pipe and fitting materials
IS
C) Weather seal, weather strip, and apply caulking - ANSWER When you have a
gap in the building envelope, what do you do to prevent air leakage?
M
A) Stuff insulation into gaps
B) Put caulking in and around the gaps
O
C) Weather seal, weather strip, and apply caulking
D) Nothing, all buildings require air leakage
A
18 inches - ANSWER In order to protect a water heater from damage, what is the
minimum height it should be from the floor of a garage?
N
4
JP
(According to the California Plumbing Code, the vertical piping between two consecutive
inlet levels shall be considered a wet-vented section. Each wet-vented section shall be
not less than one pipe size exceeding the required minimum waste pipe size of the
upper fixture or shall be one pipe size exceeding the required minimum pipe size for the
sum of the fixture units served by such wet-vented section, whichever is larger, but no
case less than 2 inches.) - ANSWER How many plumbing fixtures can be vented by
a single vertical wet-vent?
The benefits of buying summaries with Stuvia:
Guaranteed quality through customer reviews
Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.
Quick and easy check-out
You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.
Focus on what matters
Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!
Frequently asked questions
What do I get when I buy this document?
You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.
Satisfaction guarantee: how does it work?
Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.
Who am I buying these notes from?
Stuvia is a marketplace, so you are not buying this document from us, but from seller JPNAOMISTUVIA. Stuvia facilitates payment to the seller.
Will I be stuck with a subscription?
No, you only buy these notes for $12.49. You're not tied to anything after your purchase.
