100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
Test Bank For Automotive Steering, Suspension & Alignment 8th Edition by James Halderman (All Chapters 1-21) 9780135674673 £16.32   Add to cart

Exam (elaborations)

Test Bank For Automotive Steering, Suspension & Alignment 8th Edition by James Halderman (All Chapters 1-21) 9780135674673

 3 views  0 purchase
  • Module
  • Automotive Steering, Suspension & Alignment
  • Institution
  • Automotive Steering, Suspension & Alignment

Test Bank For Automotive Steering, Suspension & Alignment 8th Edition by James Halderman (All Chapters 1-21) 9780135674673

Preview 4 out of 224  pages

  • October 18, 2024
  • 224
  • 2024/2025
  • Exam (elaborations)
  • Questions & answers
  • Automotive Steering, Suspension & Alignment
  • Automotive Steering, Suspension & Alignment
avatar-seller
Automotive Steering, Suspension, & Alignment, 8e (Halderman)
Appendix 1

1) A customer complains that the steering lacks power assist all the time. Technician A says that
the power steering pump drive belt could be slipping or loose. Technician B says that worn outer
tie rod ends could be the cause. Which technician is correct?
A) Technician A only
B) Technician B only
C) Both Technicians A and B
D) Neither Technician A nor B




R
Answer: A




U
2) A front-wheel-drive vehicle pulls toward the right during hard acceleration. The most likely
cause is ________.
A) worn or defective tires




SE
B) leaking or defective shock absorbers
C) normal torque steer
D) a defective power steering rack-and-pinion steering assembly
Answer: C


IS
3) When replacing a rubber-bonded socket (RBS) tie rod end, the technician should be sure to
________.
O
A) remove the original using a special tool
B) install and tighten the replacement with the front wheels in the straight-ahead position
N
C) grease the joint before installing on the vehicle
D) install the replacement using a special clamp vise
N

Answer: B

4) Whenever installing a tire on a rim, do not exceed ________.
O



A) 25 PSI
B) 30 PSI
C




C) 35 PSI
D) 40 PSI
ED




Answer: D

5) Two technicians are discussing mounting a tire on a wheel. Technician A says that for best
balance, the tire should be match mounted. Technician B says that silicone spray should be used
M




to lubricate the tire bend. Which technician is correct?
A) Technician A only
B) Technician B only
C) Both Technicians A and B
D) Neither Technician A nor B
Answer: A




1
Copyright © 2021 Pearson Education, Inc.

,6) Technician A says that radial tires should only be rotated front to rear, never side to side.
Technician B says that vehicle manufacturers usually recommend that radial tires should be
rotated using the modified X method. Which technician is correct?
A) Technician A only
B) Technician B only
C) Both Technicians A and B
D) Neither Technician A nor B
Answer: B

7) For a tire that has excessive radial runout, Technician A says that it should be broken down on




R
a tire-changing machine and then rotated 180 degrees on the wheel and retested. Technician B
says that the tire should be replaced. Which technician is correct?




U
A) Technician A only
B) Technician B only
C) Both Technicians A and B




SE
D) Neither Technician A nor B
Answer: A

8) Technician A says that overloading a vehicle can cause damage to the wheel bearings.

tight only after seating. Which technician is correct?
A) Technician A only IS
Technician B says that tapered roller bearings used on a nondrive wheel should be adjusted hand
O
B) Technician B only
C) Both Technicians A and B
N
D) Neither Technician A nor B
Answer: C
N


9) Defective wheel bearings usually sound like ________.
A) a growl
O



B) a rumble
C) snow tires
C




D) All of the above
Answer: D
ED




10) Defective outer CV joints usually make a clicking noise ________
A) only when backing
B) while turning and moving
M




C) while turning only
D) during braking
Answer: B

11) The proper lubricant usually specified for use in a differential is ________.
A) SAE 15-40 engine oil
B) SAE 80W-90 GL-5
C) STF
D) SAE 80W-140 GL-1
Answer: B
2
Copyright © 2021 Pearson Education, Inc.

,12) A vehicle owner complained that a severe vibration was felt throughout the entire vehicle
only during rapid acceleration from a stop and up to about 20 mph (32 km/h). The most likely
cause is ________.
A) unequal drive shaft working angles
B) a bent drive shaft
C) defective universal joints
D) a bent rim or a defective tire
Answer: A




R
13) To remove a C-clip axle, what step does not need to be done?
A) Remove the differential cover




U
B) Remove the axle flange bolts/nuts
C) Remove the pinion shaft
D) Remove the pinion shaft lock bolt




SE
Answer: B

14) Drive shaft working angles can be changed by ________.
A) replacing the U-joints

C) rotating the position of the drive shaft on the yoke
D) tightening the differential pinion nut IS
B) using shims or wedges under the transmission or rear axle
O
Answer: B
N
15) A driver complains that the vehicle darts, or moves first toward one side and then to the other
side of the road. Technician A says that bump steer caused by an unlevel steering linkage could
N

be the cause. Technician B says that a worn housing in the spool valve area of the power rack
and pinion is the most likely cause. Which technician is correct?
A) Technician A only
O



B) Technician B only
C) Both Technicians A and B
C




D) Neither Technician A nor B
Answer: A
ED




16) A vehicle equipped with power rack-and-pinion steering is hard to steer when cold only.
After a couple of miles of driving, the steering power assist returns to normal. The most likely
cause of this temporary loss of power assist when cold is ________.
M




A) a worn power steering pump
B) worn grooves in the spool valve area of the rack-and- pinion steering unit
C) a loose or defective power steering pump drive belt
D) a defective power steering computer sensor
Answer: B




3
Copyright © 2021 Pearson Education, Inc.

, 17) A dry park test is performed ________.
A) on a frame-type lift with the wheels hanging free
B) by pulling and pushing on the wheels with the vehicle supported by a frame-type lift
C) on the ground or on a drive-on lift by moving the steering wheel while observing for
looseness
D) driving in a figure 8 in a parking lot
Answer: C

18) On a parallelogram-type steering linkage, the part that usually needs replacement first is the
________.




R
A) pitman arm
B) outer tie rod end(s)




U
C) center link
D) idler arm
Answer: D




SE
19) What parts need to be added to a "short" rack to make a "long" rack-and-pinion steering unit?
A) Bellows and ball socket assemblies
B) Bellows and outer tie rod ends
C) Ball socket assemblies and outer tie rod ends
D) Outer tie rod ends
Answer: A IS
O
20) The adjustment procedure for a typical integral power steering gear is ________.
N
A) overcenter adjustment, then worm thrust bearing preload
B) worm thrust bearing preload, then overcenter adjustment
N

C) stub shaft adjustment, then overcenter adjustment
D) intermediate shaft adjustment, then worm gear
E) adjustment
O



Answer: B
C




21) A vehicle is sagging at the rear. Technician A says that standard replacement shock
absorbers should restore proper ride (trim) height. Technician B says that replacement springs
ED




are needed to properly restore ride height. Which technician is correct?
A) Technician A only
B) Technician B only
C) Both Technicians A and B
M




D) Neither Technician A nor B
Answer: B




4
Copyright © 2021 Pearson Education, Inc.

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller MedConnoisseur. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for £16.32. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

76799 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy revision notes and other study material for 14 years now

Start selling
£16.32
  • (0)
  Add to cart