Journeyman Bundled Exams ( Full Solution Pack) Updated & Verified | Guaranteed Success

Defects on gas piping or fittings shall be _____.(A) repaired(B) replaced or repaired and retested(C) repaired by a certified welder(D) ignored, as the operating pressure is much less than the air test. - B. Fitting shall be replaced or repaired and retested. UMC Section 1316.4.3 Every absorption...

An advantage of an electromagnet over a permanent magnet is that... - an electromagnet can be switched. An excellent diffuser surface is one that... - scatters light uniformly in all directions Light is converted into electricity... - in a photovoltaic cell The rotating part in a DC motor is kno...

There are six conductors in a race way connected to 75° C rated circuit breaker. Each wire has a 70 amp load using THHM conductors. The minimum size conductors used our #_________AWG - 4 Thermal insulation shall not be installed within _________inches of recessed lighting fixtures - 3 A 1 inch...

An advantage of an electromagnet over a permanent magnet is that ____. - An electromagnet can be switched on and off. An excellent diffuser surface is one that ____. - Scatters light uniformly in all directions. Light is converted into electricity ____. - In a photovoltaic cell. The rotating par...

How many apprentices can a journeyman directly supervise? - 2 When performing any service work on a customers heating system the licensee must notify the homeowner of? - Efficiency and code violations Can a licensed journeyman perform a cleaning on wood/oil combination unit without direct superv...

Grounding and Bonding: Where outside, aluminum or copper-clad aluminum grounding electrode conductors shall not be terminated within ____in. of Earth. A. 12 in. B. 18 in. C. 24 in. D. 36 in. - B. 18 in. 250.64(A) Temporary Installations: When used by personnel during construction, remodeli...

where extensive metal in or on buildings or structures may become energized and is subject to personal contact _______ will provide additional safety. a) adequate bonding and grounding b) bonding c) suitable ground detectors d) none of these - a) adequate bonding and grounding single conductor...

Conductors with _____ marked on the insulation are NOT approved for use in a wet location. - THHN conductors with THHN insulation are approved for use in dry and damp locations only and conductors with THWN, THHW, and THW insulation are recognized for use in dry and wet locations. Given: A one-...

A fixed light will be allowed to be 30 amp provided the socket is rated ____ duty. a. Light b. Medium c. Heavy d. Extra Heavy - c. Heavy From the Skilled Trades Act, Section 7 "Except as otherwise provided in this article or in subsection (3), and individual other than an individual who is li...

What table sizes bonding jumpers for for AC systems? - 250.102(C)(1) The NEC defines continuous load to be a load where max current on the circuit continues for at least how many hours? - Three To use the adjustment factors in table 310.15(B)(3)(A), you must have greater than how many current ca...

Where a water pipe passes over an indoor motor control center, leak protection apparatus shall have a MINIMUM clearance of _____. a) 6 feet to the protection apparatus b) 6 feet to the water pipe c) 6 1⁄2 feet to the protection apparatus d) 6 1⁄2 feet to the water pipe - A: 6 feet to the pr...

Where the outer sheath of Type MI cable is made of steel _____________. A. it shall provide an adequate path to serve as an equipment grounding conductor B. a separate equipment grounding conductor shall be provided C. the grounding and grounded conductors shall be connected together D. it shall...