ASE Bundled Exams Questions and Answers 2024

ASE Certification Practice Exam Both b and c - Answer ️️ -Coolant should be tested for ________. Proper color Freezing point (temperature) Specific Gravity Both b and c Both technician a and b - Answer ️️ -Two technicians are discussing a compression test. Technician A says that the e...

ASE certification Exam 2024 The air pressure at the inlet of the HVLP gun is normally between: A.10-30 psi B.30-50 psi C.50-70 psi D. none of the above - Answer ️️ -B:30-50 psi Painter A says that primer-surfacer will dry faster if sprayed in several coats with flash time between coats. P...

ASE BRAKES Exam 1 Questions and Answers Rated A A - Answer ️️ -A drum is chattering on the brake lathe. This could be the result of: A. Failure to install the dampening belt. B. Cutting too slowly. C. Dull cutting blades. D. Cutting speed too fast. C - Answer ️️ -A vehicle is equipped...

ASE G1 Questions and Answers 100% Pass Technician A says that when pressure testing a radiator cap, a special adapter is needed. Technician B says the best way to check thermostat operation is while it is in the engine. Who is right? - Answer ️️ -Tech A A technician is checking resistance in...

ASE A1 (Engine Repair) Practice Test – Cumulative Already Passed an engine miss is being diagnosed using a cylinder leakage test. Technician A says that any cylinder with over 20% leakage has excessive leakage. Tech B says that air leaking from the tailpipe indicates a cracked cylinder. A onl...

Service Consultant ASE test prep with verified solutions An automotive repair business makes it money mainly by: - Answer ️️ -Selling the labor of a trained technician to the customer Whose job is it to work directly with the customer and technicians to arrange for diagnosis, repair, and se...

ASE: Steering and Suspension Questions and Answers 100% Pass How would you adjust a rack yoke bearing? - Answer ️️ -Tighten, then look at OEM specifications and back off by the suggested amount of degrees. If a customer states that their steering wheel turns more to the left than to the righ...

ASE A4 practice test questions and answers 100% pass 2. A driver says that the front end of his car vibrates up and down while traveling at most road speeds. Tech A says that too much runout of the front wheels could be the cause. Tech B says that a static out of balance of the front wheels could...

ASE A6 practice test questions and answers 100% pass B- Always disconnect the ne the negative battery cable and wrap with tape so contract cannot be made. Follow the specific vehicle's disarming instructions, as some SRS system can retain back up power for an additional period of time. - Answer ...

ASE G1 Questions and Answers A tight timing belt makes what type of noise? - Answer ️️ -Whining A RWD (rear wheel drive) transmission has a leaking output shaft seal on a vehicle with 25,000 miles on the odometer. The MOST likely cause for the leakage is: - Answer ️️ -Plugged Transmissio...

ASE A3 Questions and Answers 100% Pass Noise: In gear, clutch disengaged (pedal to floor) - Answer ️️ -Pilot bushing or bearing Noise: Neutral, clutch disengaged (pedal to floor) - Answer ️️ -Release bearing Noise: Neutral, clutch engaged (pedal up) - Answer ️️ -Input shaft bearing B...

ASE - Engine Repair Questions and Answers Already Passed Technician B says that Part 'X' is used to correct installed spring height. Who is right? - Answer ️️ -B. Technician B only A compression test shows that one cylinder is too low. A leakage test on that cylinder shows that there is e...

ASE certification study guide questions and answers 100% pass Spark plugs are being replaced on a v6 engine. Which of the following should be performed before removing the boot? - Answer ️️ -Twist the boot 1/2 a turn Technician A days that a positive crankcase ventilation (pvc) system reduce...

ASE A5 Practice Test Brakes Exam A vehicle with ABS anti-lock brakes has an audible clicking noise when it is first started. The noise goes away after a few seconds. Technician A says this is one of the hydraulic valves in the hydraulic valve assembly sticking. Technician B says this is a normal ...