package deal of ASE Correctly Answered Graded A+.

How would you adjust a rack yoke bearing? - correct answer Tighten, then look at OEM specifications and back off by the suggested amount of degrees. If a customer states that their steering wheel turns more to the left than to the right, what are some of the most likely caus...

If an engine experiences a sharp, metallic rapping noise only when it is idling, the trouble could be worn: `Main bearings `Piston pins `connecting rod bearings `piston skirts - correct answer Piston pins On a port fuel-injected engine, the cause of excessive black sm...

an engine miss is being diagnosed using a cylinder leakage test. Technician A says that any cylinder with over 20% leakage has excessive leakage. Tech B says that air leaking from the tailpipe indicates a cracked cylinder. A only, B only, A & B, Neither . - correct answer ...

Technician A says a pilot bearing is a bushing that supports the forward end of the transmission input shaft. Technician B says a pilot bearing is a bushing that reduces friction between the clutch fork and pressure plate. Who is right? - correct answer A only. Technician A ...

Both A and B - correct answer Technician observes that the brake fluid level is at the "Min" mark in the master cylinder reservoir. Tech A says that worn front pads could be the cause. Tech B says that a leak in the brake hydraulic system could be the cause. Who is right? ...

Counterman A says "Mercon LV" transmission fluid is used in newer Ford and Mercury vehicles. Counterman B says "Dexron-VI" fluid is used in newer Chrysler vehicles. Who is right? - correct answer Counterman A only Transmission fluid that is brown and has a burnt smell: -...

A - correct answer A drum is chattering on the brake lathe. This could be the result of: A. Failure to install the dampening belt. B. Cutting too slowly. C. Dull cutting blades. D. Cutting speed too fast. C - correct answer A vehicle is equipped wi...

After a long drive red fluid is seen on the transmission case and under the chassis of a vehicle. Technician A says this can be caused by fluid aeration. Technician B says this could be caused by engine overheating. Who is correct? A. Technician A B. Technician B C. Both A and B D. Neither...

A vehicle is brought in with a bent subframe. Technician A says to section the subframe. Technician B says the subframe should not be repaired and must be replaced. Who is right? A, B, Both, or Neither - correct answer Technician B only The subframe should never be secti...

a lifting pad must be in place to lift a BMW vehicle, T or F? - correct answer True Under which section in TIS is the User Manual for the DEUTRONIC battery charger located? - correct answer Tools and Equipment Regarding BMW instrument cluster test fu...

When a diesel engine is operated under a load, coolant continually comes out of the radiator overflow and there are bubbles in the radiator. Which of these is the most likely cause? (A) Too much coolant in the cooling system (B) A clogged radiator (C) A stuck-open thermostat (D) Compression l...

how many employed in automotive field ? - correct answer 14 million define specialized tech - correct answer expert in one area of auto repair what does ASE stand for? - correct answer Automotive Service Excellence how many ASE ...

Brake Pad Minimum Thickness Customer Pay Warranty CPO - correct answer Customer Pay: 3mm Warranty: 4mm (3.9mm) CPO: 5 mm Brake bleed pressure setting (bar): - correct answer 2 bar max - Location of MSDS: - correct answer On...

A CCOT system has a high high side. Technician A says to suspect the thermostatic expansion valve. Technician B says this system contains an orifice tube. Who is correct? - correct answer TECH B is correct. A clogged orifice tube will result in high high side pressure. It can b...