MILLWRIGHT BUNDLED EXAM 2024 WITH 100% CORRECT ANSWERS

1. When the downward force at C2 is 100 lb and D2 = 2.5 inches, the upward force at C1 will be ________lb if D1 = 4 inches. A. 160 B. 256 C. 384 D. 240 - correct answer A. 160 x/12.56 sq in = 100 lbs/7.85 sq in x = (100lbs/7.85 sq in)12.56 x = 160 lbs 2. Add the following decimals an...

MILLWRIGHT EXAM 2024 WITH 100 % CORRECT ANSWERS 1. When the downward force at C2 is 100 lb and D2 = 2.5 inches, the upward force at C1 will be ________lb if D1 = 4 inches. A. 160 B. 256 C. 384 D. 240 - correct answer A. 160 x/12.56 sq in = 100 lbs/7.85 sq in x = (100lbs/7.85 sq i...

1. How is efficiency found? A) output over input B) input over output C) output times input times 100 D) output times input divided by hp - correct answer A) Output over input 2. What is the maximum capacity in kg of a heavy duty ladder? A) 136 B) 113 C) 102 D) 91 - correct answer B)1...

On a pedestal grinder, the gap between the grinding wheel and work rest should not exceed: - correct answer 1/8 inch The kind of abrasive material used in grinding wheels for general purpose applications is: - correct answer aluminum oxide A blotter is used on a grinding wheel to: - correct an...

The best method of alignment to apply when shafts can not be axially secured is? - correct answer cross dialing Sag corrections in dial setting are applied only to? - correct answer vertical rim readings limitations in use of cross dialing methods include substantial brackets for long spans, l...

which of the following tools would be used on a polished steel assembly. - correct answer strap wrench The type of wrench designed for use on a specific part is the ______ wrench. - correct answer Spanner what kind of tool do you use for packing. - correct answer Packing gauge Can you use a...

MILLWRIGHT NCCER EXAM 2024 WITH 100% CORRECT ANSWERS

Which of the following best describes a free flow control valve? A) It is the simplest form of directional control allowing flow in one direction only B) They are used to prevent a load suspended by a cylinder from free fall C) They operate actuators at different times D) They make a humming sou...

Which of the following best describes a free flow control valve? A) It is the simplest form of directional control allowing flow in one direction only B) They are used to prevent a load suspended by a cylinder from free fall C) They operate actuators at different times D) They make a humming sou...

MILLWRIGHT RIGGING & LIFTING EXAM 2024 100% CORRECT ANSWERS The breaking strength of rope is a. force needed to pull rope b. force needed to tear rope c. force needed to break the rope d. force needed to stretch rope - correct answer c. force needed to break the rope What are spreader be...

If the seal was not properly aligned or there is excessive wear in some bearing or shaft______ wear tracks will be the indicator. - correct answer Unusual For removing hard to remove gasket materials found on sealing surfaces ______ is recommended. - correct answer sharpened brass putty knife ...

A ______ conveys a liquid. - correct answer Pump What are the two main categories of pumps? - correct answer Centrifugal and positive displacement Pumps at a constant capacity regardless of pressure. - correct answer Positive displacement Which pump does not see a decrease in flow with an i...