ASE A6 Electrical Systems Certification Q&A Bundle

A late model vehicle is being diagnosed for an inoperative heated steering wheel. Tech A says that a faulty clock spring could cause this problem. Tech B says that the steering wheel heater grid can be replaced without removing the steering wheel. Who is correct? a. A only b. B only c. Both A+...

How are voltage tests measured? Voltage tests are measured with the test leads of the DMM in parallel to the component or circuit being tested. How do you test applied voltage? 1. In testing applied voltage, the negative or black test lead of the DMM is connected to a battery or chassis ground 2...

A control module needs to be programmed following the replacement of the hardware. Tech A says that a multimeter will be needed to measure the resistance of the new software. Tech B says that a module programming database is needed to retrieve the correct program to upload to the new module.Tech B i...

All the lights in a brake light circuit illuminate except one. The MOST likely cause is: A. an open wire B. an open taillight switch C. a blown fuse D. a burned bulb D. a burned bulb If a tech reversed the leads of a digital voltmeter on a 12v circuit the readout would show: A. 0.00v B. -0....

1. When using a DMM (Digital Multimeter) voltmeter function to check for a voltage drop, meter leads should be connected in which of the following ways? a. On the "positive" side of the circuit b. Across the component or circuit c. To any non-conductive material d. In series with the circ...