OSHA 30 Final/72 Questions with
complete solutions
On jobsites without an employee rep. how many employees must the CSHO
consult with concerning matters of Health and Safety in the workplace? - -A
reasonable number of employees
-Jobsites must have a safety and health program. The program must provide
_______ inspections of the jobsite, materials, and equipment by a competent
person - -Frequent and Regular
-The employer must instruct each employee in the recognition and
avoidance of ___________ and the regulations applicable to his/her work
environment to control or eliminate any hazards or other exposure to illness
or injury - -Unsafe Conditions
-In order to qualify for a focused inspection an employee has to have a
designated ________ person who is responsible for implementing the program
plan - -Competent
-What should the assessment of employer's safety and health programs
consider? - -All of the above
-On multi-employer work sites citations are _________ issued to employers
whos employees are exposed to hazards. - -Normally
-On multi-employer work sites an employer can be cited whether or not their
_______ - -Employee is exposed to a hazard
-The fall protection requirements of Subpart M do not apply to the following
situations; - -Steel Erection
-As of January 1, 1998 _____ are not acceptable as part of a personal fall
arrest system. - -Body belts and non-locking snaphooks
-The side rails of a portable ladder must extend __ inches above the landing
when grab rails are not provided - -36
-Rungs of a ladder must be ____ inches apart - -10 to 12
-When must a "competent" person inspect a scaffold - -All of the above
-How high are you allowed to build a scaffold that is 5 feet wide by 7 feet
long before you have to tie, guy, or brace the scaffold? - -20 feet
, -A connector (ironworker) is connecting a beam while exposed to an exterior
fall of 35 feet to the ground below. What OSHA standard applies? - -
1926.760(b)(1)
-Which of the following does not apply to all construction projects? - -A
trained and equipped firefighting organization (fire brigade) to assure
adequate protection of life.
-Which of the following types of portable firefighting equipment is
prohibited? - -A carbon Tetrachloride type fire extinguisher
-Signs and symbols required by Subpart G-O-W must be seen... - -When
work is being performed.
-When operations are such that signs, signals, and barricades do not provide
the necessary protection for employees on or next to a highway; - -Flaggers
or other appropriate traffic controls must be provided
-All 120-volt, single phase, 15- and 20-ampere receptacle outlets on
construction sites that are not part of the permanent wiring must have - -
GFCI's
-If an employer chooses not to utilize GFCI's the jobsite must have - -
Assured equipment grounding conductor programs
-Circular saw, chain saws, and percussion tools must have what type of shut
off switch - -Constant Pressure Switch
-Powder Actuated tools must be loaded - -Just prior to the intended firing
time
-All protruding reinforcing steel on which an employee could fall must
__________ to eliminate a hazard - -Be guarded
-Precast concrete panel lifting inserts must be capable of supporting at least
______ times the maximum intended lifting load - -2
-What are the basic hazards involved when working with compressed gas
cylinders - -All of the above
-When can compressed gas cylinders be used for rollers? - -Should never be
used as rollers
-The employer must comply with the manufacturers specification and
limitations applicable to the operation of what type of crane? - -All Cranes
complete solutions
On jobsites without an employee rep. how many employees must the CSHO
consult with concerning matters of Health and Safety in the workplace? - -A
reasonable number of employees
-Jobsites must have a safety and health program. The program must provide
_______ inspections of the jobsite, materials, and equipment by a competent
person - -Frequent and Regular
-The employer must instruct each employee in the recognition and
avoidance of ___________ and the regulations applicable to his/her work
environment to control or eliminate any hazards or other exposure to illness
or injury - -Unsafe Conditions
-In order to qualify for a focused inspection an employee has to have a
designated ________ person who is responsible for implementing the program
plan - -Competent
-What should the assessment of employer's safety and health programs
consider? - -All of the above
-On multi-employer work sites citations are _________ issued to employers
whos employees are exposed to hazards. - -Normally
-On multi-employer work sites an employer can be cited whether or not their
_______ - -Employee is exposed to a hazard
-The fall protection requirements of Subpart M do not apply to the following
situations; - -Steel Erection
-As of January 1, 1998 _____ are not acceptable as part of a personal fall
arrest system. - -Body belts and non-locking snaphooks
-The side rails of a portable ladder must extend __ inches above the landing
when grab rails are not provided - -36
-Rungs of a ladder must be ____ inches apart - -10 to 12
-When must a "competent" person inspect a scaffold - -All of the above
-How high are you allowed to build a scaffold that is 5 feet wide by 7 feet
long before you have to tie, guy, or brace the scaffold? - -20 feet
, -A connector (ironworker) is connecting a beam while exposed to an exterior
fall of 35 feet to the ground below. What OSHA standard applies? - -
1926.760(b)(1)
-Which of the following does not apply to all construction projects? - -A
trained and equipped firefighting organization (fire brigade) to assure
adequate protection of life.
-Which of the following types of portable firefighting equipment is
prohibited? - -A carbon Tetrachloride type fire extinguisher
-Signs and symbols required by Subpart G-O-W must be seen... - -When
work is being performed.
-When operations are such that signs, signals, and barricades do not provide
the necessary protection for employees on or next to a highway; - -Flaggers
or other appropriate traffic controls must be provided
-All 120-volt, single phase, 15- and 20-ampere receptacle outlets on
construction sites that are not part of the permanent wiring must have - -
GFCI's
-If an employer chooses not to utilize GFCI's the jobsite must have - -
Assured equipment grounding conductor programs
-Circular saw, chain saws, and percussion tools must have what type of shut
off switch - -Constant Pressure Switch
-Powder Actuated tools must be loaded - -Just prior to the intended firing
time
-All protruding reinforcing steel on which an employee could fall must
__________ to eliminate a hazard - -Be guarded
-Precast concrete panel lifting inserts must be capable of supporting at least
______ times the maximum intended lifting load - -2
-What are the basic hazards involved when working with compressed gas
cylinders - -All of the above
-When can compressed gas cylinders be used for rollers? - -Should never be
used as rollers
-The employer must comply with the manufacturers specification and
limitations applicable to the operation of what type of crane? - -All Cranes
