Spectrum Field Tech New Hire Week 2
Exam
In a coaxial cable, where does radio frequency travel? - -Near the surface of
the center conductor
-Attenuation is the signal loss caused by cable length. It is measured in what
unit? - -dB
-The length of coaxial cable is directly proportional to the ____________ that
will be suffered in the signal strength. - -Loss
-What is the base temperature used in cable attenuation charts? - -68
Degrees F
-100% ________ would make the best dielectric due to its non conductive
properties. - -Plastic
-Your hardhat protects you from - -Impact - Penetration - Electric Shock
-Which standard is imprinted on glasses or goggles that meet safety
requirements? - -ANSI Standard Z87.1-2010
-Which items of PPE do you need under normal working conditions ( not
climbing ) ? - -Hard hat, Safety glasses, Safety vest, FVD, and gloves
-Which items of PPE would you need when working aloft on a ladder? - -
Hard hat, Safety glasses, FVD, Long-sleeved shirt, Gloves, Body belt,
Positioning strap, and Linemans boots
-What happens to leather when it is dried too fast in excessive heat? - -The
leather curls and cracks
-How do you measure for proper "D" size on a padded body belt? - -Measure
hipbone to hipbone plus 2
-Once at the working height , pass the positioning strap around the pole and
engage the single-sided end on the D-ring with the mouth of the snap hook
_________ . - -inward
-Always verify visually that the snap hook had engaged the _________________
. - -D - Ring
Exam
In a coaxial cable, where does radio frequency travel? - -Near the surface of
the center conductor
-Attenuation is the signal loss caused by cable length. It is measured in what
unit? - -dB
-The length of coaxial cable is directly proportional to the ____________ that
will be suffered in the signal strength. - -Loss
-What is the base temperature used in cable attenuation charts? - -68
Degrees F
-100% ________ would make the best dielectric due to its non conductive
properties. - -Plastic
-Your hardhat protects you from - -Impact - Penetration - Electric Shock
-Which standard is imprinted on glasses or goggles that meet safety
requirements? - -ANSI Standard Z87.1-2010
-Which items of PPE do you need under normal working conditions ( not
climbing ) ? - -Hard hat, Safety glasses, Safety vest, FVD, and gloves
-Which items of PPE would you need when working aloft on a ladder? - -
Hard hat, Safety glasses, FVD, Long-sleeved shirt, Gloves, Body belt,
Positioning strap, and Linemans boots
-What happens to leather when it is dried too fast in excessive heat? - -The
leather curls and cracks
-How do you measure for proper "D" size on a padded body belt? - -Measure
hipbone to hipbone plus 2
-Once at the working height , pass the positioning strap around the pole and
engage the single-sided end on the D-ring with the mouth of the snap hook
_________ . - -inward
-Always verify visually that the snap hook had engaged the _________________
. - -D - Ring
