100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached
logo-home
Hvac Journeyman Exam $9.99   Add to cart

Exam (elaborations)

Hvac Journeyman Exam

 11 views  0 purchase
  • Course
  • Institution

Hvac Journeyman Exam Defects on gas piping or fittings shall be _____.(A) repaired(B) replaced or repaired and retested(C) repaired by a certified welder(D) ignored, as the operating pressure is much less than the air test. - B. Fitting shall be replaced or repaired and retested. UMC Section 1...

[Show more]

Preview 3 out of 19  pages

  • April 25, 2024
  • 19
  • 2023/2024
  • Exam (elaborations)
  • Questions & answers
avatar-seller
Hvac Journeyman Exam
Defects on gas piping or fittings shall be _____.(A) repaired(B) replaced or repaired and

retested(C) repaired by a certified welder(D) ignored, as the operating pressure is much less than

the air test. - ✔✔B. Fitting shall be replaced or repaired and retested. UMC Section 1316.4.3



Every absorption refrigerating system supported from the ground shall rest on a concrete slab

extending not less than _____ the adjoining ground level.(A) 3 inches below(B) 3 inches above

(C) 6 inches below(D) 6 inches above. - ✔✔B. Slab extending not less than 3" above the

adjoining ground level. UMC Section 1106.2



Any part of a venting system installed at an angle greater than 45 degrees from the vertical is

considered by code to be _____.(A) vertica(B) horizontal l (C) a flat vent (D) an offset vent -

✔✔B. any part of the venting installed at an angle GREATER than 45 degrees is considered by

this code to be Horizontal UMC Section 802.6.1.1



Listed transition ducts f or clothes dryers shall not exceed_____ feet in length. A.3 B.4 C.5 D.6. -

✔✔D. Dryers shall not exceed 6 feet in length. UMC Section 504.3.2.1



Industrial product-conveying ducts and their fittings for abrasive and nonabrasive dust or solid

materials shall be constructed of _____.(A) sheet meta(B) polyvinyl chloride l (C) fiberglass (D)

A and C apply - ✔✔A. Shall Be Constructed of sheet metal. UMC Section. 5 0 6.1

,Industrial product-conveying ducts and their fittings for abrasive and nonabrasive dust or solid

materials shall be constructed of _____.(A) sheet metal ((B) polyvinyl chloride C) fiberglass (D)

A and C apply - ✔✔A 511.2



Unlisted vented gas fireplaces shall have a clearance at the sides and rear of not less than _____

inches. Is the Answer: A. 10" B. 12" C 16" D. 18". - ✔✔D. clearance of an unlisted vented gas

fireplace at the sides and the rear not less than 18". UMC Section 908.2(B)



Leaks in gas piping shall be located _____.(A) with a sniffer(B) with a presto-lite flame (C) with

a noncorrosive leak-detecting fluid (D) by increasing the air pressure during a test until the leaks

are heard as a whistle. - ✔✔C. leaks in a gas piping shall be located with a non corrosive leak

detecting fluid. UMC Section 1316.4.2



Condensate drain piping shall have a slope of not less than _____ inch per foot. A 1⁄8" B.¼"

C.½" D. 1" - ✔✔A. Slope of not less than 1/8" per foot. UMC Section 309.1



The minimum gauge or size steel wire used to support horizontal metal ducts 10 inches or less in

size is _____. A.14 AWG B.16 AWG C.18 AWG D.20 AWG - ✔✔C. 18 Minimum Gauge note:

AWG is the abbreviation for "gauge size" Table 6-7(B)



When smoke detectors are required as part of an automatic shutoff system, they shall be installed

in the _____. A. return air duct ahead of any fresh-air inlet(B) main supply air duct served by

, such equipment(C) fresh-air inlet(D) main return and the main supply duct. - ✔✔B. shall be

installed in the main supply air duct served by equipment. UMC Section 609.0(5)



The largest fuel-burning appliance allowed in a room 100'W x 20'L x 8'H without combustion air

openingsis _____ Btu.(A) 80,000 (C) 140,000(B) 100,000 (D) 320,000 - ✔✔31 D. 701.2.1



Return air ducts that serve a dwelling unit shall be permitted to be of _____ construction? A.non-

combustible B. combustible C. rated D. none of the above. - ✔✔B. Shall be permitted to be of

combustible type UMC Section 602.2 Ex (1)



Solid fuel-burning appliances _____ be connected to a venting system that serves a gas- or oil-

burningappliance.(A) shall (B) may (C) shall not(D) with special approval may - ✔✔C.

appliances shall not UMC Section 802.5.5.1



Any joint obtained by joining of metal parts with alloys that melt at temperatures higher than

840°F, but lowerthan the melting temperature of the parts to be joined, is a _____ joint.(A)

brazed(B) fused (D) soldered (C) welded - ✔✔A. Is a brazed joint UMC section 2 1 2.0



A vessel or arrangement of piping or tubing in which vaporized refrigerant is liquefied by

removal of heat is a _____.(A) compressor (C) evaporator(B) generator (D) condenser - ✔✔D. A

condenser is the piping which vaporizes the refrigerant liquefied by removal of heat, UMC

Section 2 0 5.0

The benefits of buying summaries with Stuvia:

Guaranteed quality through customer reviews

Guaranteed quality through customer reviews

Stuvia customers have reviewed more than 700,000 summaries. This how you know that you are buying the best documents.

Quick and easy check-out

Quick and easy check-out

You can quickly pay through credit card or Stuvia-credit for the summaries. There is no membership needed.

Focus on what matters

Focus on what matters

Your fellow students write the study notes themselves, which is why the documents are always reliable and up-to-date. This ensures you quickly get to the core!

Frequently asked questions

What do I get when I buy this document?

You get a PDF, available immediately after your purchase. The purchased document is accessible anytime, anywhere and indefinitely through your profile.

Satisfaction guarantee: how does it work?

Our satisfaction guarantee ensures that you always find a study document that suits you well. You fill out a form, and our customer service team takes care of the rest.

Who am I buying these notes from?

Stuvia is a marketplace, so you are not buying this document from us, but from seller ExcellentScores. Stuvia facilitates payment to the seller.

Will I be stuck with a subscription?

No, you only buy these notes for $9.99. You're not tied to anything after your purchase.

Can Stuvia be trusted?

4.6 stars on Google & Trustpilot (+1000 reviews)

67866 documents were sold in the last 30 days

Founded in 2010, the go-to place to buy study notes for 14 years now

Start selling
$9.99
  • (0)
  Add to cart