SDI Firearms Inspection and Troubleshooting (FTT 111) Study Guide Test.

SDI Firearms Inspection and Troubleshooting (FTT 111) Study Guide Test. Which of the following statements are not true about safety and ammunition? - CORRECT ANSWER Always keep ammunition in the gunsmithing area It is required to both __________________ and _____________________ once the action is open to ensure the weapon is safe. - CORRECT ANSWER Visually Check; Physically Check The initial function check is to be done: - CORRECT ANSWER With no rounds or snap caps Some break-action firearms are cocked when the __________ acts upon the _____________________ and cocks the _________________. - CORRECT ANSWER Lug; Cocking Lever; Hammer T/F: Manual Actions require the operator to use a moderate to heavy force to close the breach. - CORRECT ANSWER FALSE Revolvers will lock at about the same time when the ____________ is in its ______________ position. - CORRECT ANSWER Hammer; Cocked Which of the following firearm types "push" the extracted round from the chamber? - CORRECT ANSWER Break Action T/F: With a fixed ejector, you must quickly manipulate the action to ensure the round is properly ejected. - CORRECT ANSWER TRUE Snap caps are meant to identify which of the following malfunctions? - CORRECT ANSWER Failures to Extract, Eject, and Feed Which of the following contribute to a failure to feed? - CORRECT ANSWER Feeding Device; Action Parts; Ammunition Match the numbered step of the fire control group with its description: - CORRECT ANSWER 1) With snap caps in the chamber, set the safety in the "safe" position. 2) Depress the trigger; it will not move. 3) Release the trigger and move to "fire" position. 4) Depress the trigger again; hammer will have audible "click" 5) Continue to depress trigger, manually cycle the action and eject the snap cap. 6) Release trigger, click and hammer should not move. 7) Use a nylon or rubber hammer and tap the receiver or action. 8) Set safety to "safe" position, nothing should happen.